lkml.org 
[lkml]   [2014]   [Nov]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/5] phy: sun4i: add support for USB phy0
Date
The driver for sun4i USB phys currently supports
only phy1 and phy2 which are used for USB host
controllers. This patch adds support for USB phy0,
which is used by the musb hdrc USB controller.

Signed-off-by: Roman Byshko <rbyshko@gmail.com>
---
drivers/phy/phy-sun4i-usb.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/phy/phy-sun4i-usb.c b/drivers/phy/phy-sun4i-usb.c
index 0baf5ef..6bd2b0c 100644
--- a/drivers/phy/phy-sun4i-usb.c
+++ b/drivers/phy/phy-sun4i-usb.c
@@ -157,6 +157,10 @@ static int sun4i_usb_phy_init(struct phy *_phy)
return ret;
}

+ /* Enable USB 45 Ohm resistor calibration */
+ if (phy->index == 0)
+ sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1);
+
/* Adjust PHY's magnitude and rate */
sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5);

@@ -213,7 +217,7 @@ static struct phy *sun4i_usb_phy_xlate(struct device *dev,
{
struct sun4i_usb_phy_data *data = dev_get_drvdata(dev);

- if (WARN_ON(args->args[0] == 0 || args->args[0] >= data->num_phys))
+ if (args->args[0] >= data->num_phys)
return ERR_PTR(-ENODEV);

return data->phys[args->args[0]].phy;
@@ -255,8 +259,7 @@ static int sun4i_usb_phy_probe(struct platform_device *pdev)
if (IS_ERR(data->base))
return PTR_ERR(data->base);

- /* Skip 0, 0 is the phy for otg which is not yet supported. */
- for (i = 1; i < data->num_phys; i++) {
+ for (i = 0; i < data->num_phys; i++) {
struct sun4i_usb_phy *phy = data->phys + i;
char name[16];

--
2.1.2


\
 
 \ /
  Last update: 2014-11-10 20:21    [W:0.113 / U:4.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site