lkml.org 
[lkml]   [2014]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 10/11] irqchip: bcm7120-l2: Extend driver to support 64+ bit controllers
On Wed, Oct 29, 2014 at 12:53 AM, Arnd Bergmann <arnd@arndb.de> wrote:
> On Tuesday 28 October 2014 20:58:57 Kevin Cernekee wrote:
>> Most implementations of the bcm7120-l2 controller only have a single
>> 32-bit enable word + 32-bit status word. But some instances have added
>> more enable/status pairs in order to support 64+ IRQs (which are all
>> ORed into one parent IRQ input). Make the following changes to allow
>> the driver to support this:
>>
>> - Extend DT bindings so that multiple words can be specified for the
>> reg property, various masks, etc.
>>
>> - Add loops to the probe/handle functions to deal with each word
>> separately
>>
>> - Allocate 1 generic-chip for every 32 IRQs, so we can still use the
>> clr/set helper functions
>>
>> - Update the documentation
>>
>> Signed-off-by: Kevin Cernekee <cernekee@gmail.com>
>
> You should probably specify a 'big-endian' DT property for the driver
> to check. If you have both LE and BE versions of this device, we
> must make sure that we use the correct accessors.
>
> As long as we don't need to build a kernel that supports both (if
> I understand you correctly, the ARM SoCs use a LE instance of this
> device, while the MIPS SoCs use a BE version) you can still decide
> at compile-time which one you want, but please add the runtime check
> now, so if we ever get a new combination we can handle it at runtime
> with a more complex driver implementation.

Under discussion in the other thread...

> If I read your code right, you have decided to use one IRQ domain
> per register set, rather than one domain for all of them. I don't
> know which of the two ways is better here, but it would be good if
> you could explain in the patch description why you did it like this.

This uses one domain per bcm7120-l2 DT node. If the DT node defines
multiple enable/status pairs (i.e. >=64 IRQs) then the driver will
create a single IRQ domain with 2+ generic chips.

Multiple generic chips are required because the generic-chip code can
only handle one enable/status register pair per instance.


\
 
 \ /
  Last update: 2014-10-30 01:01    [W:0.107 / U:0.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site