lkml.org 
[lkml]   [2014]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/2] reset: Add GPIO support to reset controller framework
From
Date
Am Dienstag, den 07.01.2014, 12:19 +0100 schrieb Maxime Ripard:
> Hi Philipp,
>
> On Tue, Jan 07, 2014 at 10:52:21AM +0100, Philipp Zabel wrote:
> > > > + const char *gpio_con_id = "reset";
> > > > + struct reset_controller_dev *rcdev;
> > > > + struct reset_control *rstc;
> > > > + struct gpio_desc *gpiod;
> > > > + bool asserted = false;
> > > > + char scratch[48];
> > > > + int ret;
> > > > +
> > > > + if (id) {
> > > > + snprintf(scratch, 48, "%s-reset-boot-asserted", id);
> > > > + assert_prop = scratch;
> > > > + }
> > > > +
> > > > + asserted = of_property_read_bool(dev->of_node, assert_prop);
> > > > +
> > > > + if (id) {
> > > > + snprintf(scratch, 48, "%s-reset", id);
> > > > + gpio_con_id = scratch;
> > > > + }
> > > > +
> > > > + gpiod = gpiod_get(dev, gpio_con_id);
> > > > + if (IS_ERR(gpiod)) {
> > > > + dev_err(dev, "Failed to get GPIO reset: %ld\n", PTR_ERR(gpiod));
> > > > + return ERR_CAST(gpiod);
> > > > + }
> > > > +
> > > > + ret = gpiod_direction_output(gpiod, asserted);
> > > > + if (ret < 0)
> > > > + goto err_put;
> > >
> > > What happens if the GPIO is active low? I see no way in your binding
> > > and driver to give that information, and that would change the
> > > behaviour quite a bit.
> >
> > I was under the (wrong) impression that gpiod_direction_output takes a
> > logical value as gpiod_set_value does. Will fix that.
>
> I don't think gpiod_set_value does either unfortunately.

It does, and Alexandre (added to Cc:) suggested that
gpiod_direction_output probably should, too.
I'll send a patch.

regards
Philipp



\
 
 \ /
  Last update: 2014-01-07 13:01    [W:0.550 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site