lkml.org 
[lkml]   [2014]   [Jan]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/3] usb: musb: musb_cppi41: Make CPPI aware of high bandwidth transfers
Date
Enable CPPI to handle high bandwidth transfers, especially to support
webcam captures. Use a single bd to get the whole of the data in case of
high bandwidth transfers.

Signed-off-by: George Cherian <george.cherian@ti.com>
---
drivers/usb/musb/musb_cppi41.c | 13 +++++++++++++
1 file changed, 13 insertions(+)

diff --git a/drivers/usb/musb/musb_cppi41.c b/drivers/usb/musb/musb_cppi41.c
index f889296..39ee516 100644
--- a/drivers/usb/musb/musb_cppi41.c
+++ b/drivers/usb/musb/musb_cppi41.c
@@ -448,12 +448,25 @@ static int cppi41_dma_channel_program(struct dma_channel *channel,
dma_addr_t dma_addr, u32 len)
{
int ret;
+ struct cppi41_dma_channel *cppi41_channel = channel->private_data;
+ int hb_mult = 0;

BUG_ON(channel->status == MUSB_DMA_STATUS_UNKNOWN ||
channel->status == MUSB_DMA_STATUS_BUSY);

+ if (is_host_active(cppi41_channel->controller->musb)) {
+ if (cppi41_channel->is_tx)
+ hb_mult = cppi41_channel->hw_ep->out_qh->hb_mult;
+ else
+ hb_mult = cppi41_channel->hw_ep->in_qh->hb_mult;
+ }
+
channel->status = MUSB_DMA_STATUS_BUSY;
channel->actual_len = 0;
+
+ if (hb_mult)
+ packet_sz = hb_mult * (packet_sz & 0x7FF);
+
ret = cppi41_configure_channel(channel, packet_sz, mode, dma_addr, len);
if (!ret)
channel->status = MUSB_DMA_STATUS_FREE;
--
1.8.1


\
 
 \ /
  Last update: 2014-01-27 11:21    [W:0.050 / U:0.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site