lkml.org 
[lkml]   [2013]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC] gpio/omap: auto-setup a GPIO when used as an IRQ
On 09/23/2013 10:15 PM, Linus Walleij wrote:
> On Sun, Sep 22, 2013 at 4:40 PM, Javier Martinez Canillas
> <javier.martinez@collabora.co.uk> wrote:
>
>> To use a GPIO pin as an interrupt line, two previous configurations
>> have to be made:
>>
>> a) Map the GPIO pin as an interrupt line into the Linux irq space
>> b) Enable the GPIO bank and configure the GPIO direction as input
>>
>> Most GPIO/IRQ chip drivers just create a mapping for every single
>> GPIO pin with irq_create_mapping() on .probe so users usually can
>> assume a) and only have to do b) by using the following sequence:
>>
>> gpio_request(gpio, "foo IRQ");
>> gpio_direction_input(gpio);
>>
>> and then request a IRQ with:
>>
>> irq = gpio_to_irq(gpio);
>> request_irq(irq, ...);
>
> I guess I have to live with this approach, but I'd like to - if possible -
> address my pet issue.
>
> - It is OK that the HW get set up as GPIO input by the IRQ
> request function alone. (Through gpio_irq_type I guess).
>

Yes, this is how is made on this patch indeed.

> - When a second caller calls omap_gpio_request() it should
> be OK as well, but only if the flags corresponds to the
> previously enabled input mode. Else it should be
> disallowed.
>
> - The same should happen for _set_gpio_direction() if a pin
> previously set up for IRQ gets a request to be used as
> output.
>
> If this cannot be tracked in the driver, it is certainly a candidate
> for something that gpiolib should be doing. And then I'm open to
> solutions to how we can do that.
>

Ok, this can be tracked in the driver, will add it when posting v2 soon.

> If this needs to be applied pronto to fix the regression I'm
> happy with that too, if we add a big boilerplate stating the above
> problem and that it needs to be *fixed* at some point.
>
> But in either case I want this to be tested on OMAP1 before
> I apply it, as in a Tested-by tag.
>

Agreed. Even though this is a fix for a long standing issue I prefer it to be
tested extensively than applying the patch in a rush just to learn that causes
regressions and have to be reverted as it happens last time.

So as you said let's wait until we have a few Tested-by tags by people using
different OMAP platforms specially OMAP1.

> Yours,
> Linus Walleij
>

Thanks a lot and best regards,
Javier



\
 
 \ /
  Last update: 2013-09-24 08:01    [W:0.150 / U:2.132 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site