lkml.org 
[lkml]   [2013]   [Sep]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFC PATCH 06/15] phy: omap-pipe3: update compatibility string and DT binding
Date
Improve compatibility string format to "ti,phy-pipe3-<type>"
where <type> can be "usb3" or "sata". Remove "pcie" type
as it is not yet supported due to missing DPLL data.

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
Documentation/devicetree/bindings/phy/omap-phy.txt | 3 +--
drivers/phy/phy-omap-pipe3.c | 8 ++------
2 files changed, 3 insertions(+), 8 deletions(-)

diff --git a/Documentation/devicetree/bindings/phy/omap-phy.txt b/Documentation/devicetree/bindings/phy/omap-phy.txt
index cf45b01..8e09ad3 100644
--- a/Documentation/devicetree/bindings/phy/omap-phy.txt
+++ b/Documentation/devicetree/bindings/phy/omap-phy.txt
@@ -47,8 +47,7 @@ usb2phy@4a0ad080 {
OMAP PIPE3 PHY

Required properties:
- - compatible: Should be "ti,omap-usb3", "ti,omap-pipe3", "ti,omap-sata"
- or "ti,omap-pcie"
+ - compatible: Should be "ti,phy-pipe3-usb3" or "ti,phy-pipe3-sata"
- reg : Address and length of the register set for the device.
- reg-names: The names of the register addresses corresponding to the registers
filled in "reg".
diff --git a/drivers/phy/phy-omap-pipe3.c b/drivers/phy/phy-omap-pipe3.c
index 19d1664..67eeaeb 100644
--- a/drivers/phy/phy-omap-pipe3.c
+++ b/drivers/phy/phy-omap-pipe3.c
@@ -219,17 +219,13 @@ static struct phy_ops ops = {
#ifdef CONFIG_OF
static const struct of_device_id omap_pipe3_id_table[] = {
{
- .compatible = "ti,omap-pipe3",
+ .compatible = "ti,phy-pipe3-usb3",
.data = dpll_map_usb,
},
{
- .compatible = "ti,omap-sata",
+ .compatible = "ti,phy-pipe3-sata",
.data = dpll_map_sata,
},
- {
- .compatible = "ti,omap-usb3",
- .data = dpll_map_usb,
- },
{},
};
MODULE_DEVICE_TABLE(of, omap_pipe3_id_table);
--
1.7.4.1


\
 
 \ /
  Last update: 2013-09-19 15:21    [W:0.229 / U:5.612 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site