lkml.org 
[lkml]   [2013]   [Aug]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 1/1 resend] i2c: rcar: modify I2C driver
Hi Wolfram,

Thank your for the guide.

I have understood your guide.
And I have released version 4 of I2C patch.

Please check it for me.

Thanks,
Nguyen Viet Dung

On 08/28/2013 06:02 PM, Wolfram Sang wrote:
> On Tue, Aug 27, 2013 at 04:55:22PM +0900, Nguyen Viet Dung wrote:
>> This patch modify I2C driver of rcar-H1 to usable on both rcar-H1 and rcar-H2.
>>
>> Signed-off-by: Nguyen Viet Dung <nv-dung@jinso.co.jp>
> Yes, this is much better. Only minor things...
>
>> + switch (priv->devtype) {
>> + default:
>> + case I2C_RCAR_H1:
>> + cdf_width = 2;
>> + break;
>> + case I2C_RCAR_H2:
>> + cdf_width = 3;
>> + break;
>> + }
>> +
> Please put the default case block at the end.
>
>> @@ -632,6 +649,13 @@ static int rcar_i2c_probe(struct platform_device *pdev)
>> bus_speed = 100000; /* default 100 kHz */
>> if (pdata && pdata->bus_speed)
>> bus_speed = pdata->bus_speed;
>> +
>> + if (!pdev->id_entry) {
>> + dev_err(&pdev->dev, "no entry\n");
>> + return -ENODEV;
>> + }
> This cannot happen. Since you have 'i2c-rcar' in the id_table, the
> driver core will always match against the id_table and there is always a
> driver_data defined.
>
>
>> + priv->devtype = pdev->id_entry->driver_data;
> Basically the same, but please use
>
> platform_get_device_id(pdev)->driver_data;
>
> Otherwise good!
>
> Thanks,
>
> Wolfram



\
 
 \ /
  Last update: 2013-08-30 08:41    [W:0.053 / U:0.652 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site