lkml.org 
[lkml]   [2013]   [Aug]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] Documentation: document all g_serial module parameters
Date
Add a table explaining the module parameters that g_serial
digests.

Signed-off-by: Matt Porter <matt.porter@linaro.org>
---
Documentation/usb/gadget_serial.txt | 13 +++++++++++++
1 file changed, 13 insertions(+)

diff --git a/Documentation/usb/gadget_serial.txt b/Documentation/usb/gadget_serial.txt
index 61e67f6..d5eb27b 100644
--- a/Documentation/usb/gadget_serial.txt
+++ b/Documentation/usb/gadget_serial.txt
@@ -125,6 +125,19 @@ controller driver. This must be done each time you reboot the gadget
side Linux system. You can add this to the start up scripts, if
desired.

+Additionally, there are several module parameters to change g_serial
+behavior:
+
+ Parameter Default Description
+ --------- ------- -----------
+ use_acm 1 CDC ACM device
+ use_obex 0 CDC OBEX device
+ n_ports 1 Ports to instantiate
+
+To load g_serial as two ACM ports do this:
+
+ modprobe g_serial n_ports=2
+
Your system should use mdev (from busybox) or udev to make the
device nodes. After this gadget driver has been set up you should
then see a /dev/ttyGS0 node:
--
1.7.9.5


\
 
 \ /
  Last update: 2013-08-15 23:41    [W:0.032 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site