lkml.org 
[lkml]   [2013]   [Jun]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH] regulator: palmas: enable all modes for SMPS10
Hi,

On Tuesday 04 June 2013 03:08 PM, Mark Brown wrote:
> On Tue, Jun 04, 2013 at 02:38:08PM +0530, Kishon Vijay Abraham I wrote:
>> On Sunday 02 June 2013 02:35 AM, Mark Brown wrote:
>
>>> This is still not making any sense. The quality of regulation and
>>> output voltage are essentially orthogonal, and obviously there's a
>>> specific API for bypass which is something different again to both
>>> mode and output voltage selection.
>
>> Do you recommend adding API's (similar to bypass) for BOOST and SWITCH?
>
> No. A boost regulator is still a voltage regulator, it just happens to
> raise rather than lower the voltage but it's otherwise a normal
> regulator. I'm not sure what you mean by "SWITCH" - from the name it'd
> just be a bypass?

Copy-pasting Laxman's explanation

<...>

Palma have SMPS10 regulator which can generate two voltage level 3.75
and 5V.
This SMPS10 has the two outputs OUT1 and OUT2 and having one input IN1.

SMPS10-OUT2 is always connected to SMPS10-IN1 via following logic:
- Through parasitic diode (no sw control)
- In bypass mode (bit configuration is there to enable/disable Bypass)
- In Boost mode (bit configuration is there to enable/disable Boost mode)

SMPS10-OUT1 is connected to the SMPS10-OUT2 pin through Switch (SW
control for enabling/disabling this switch).

<...>

Thanks
Kishon


\
 
 \ /
  Last update: 2013-06-04 12:21    [W:0.064 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site