lkml.org 
[lkml]   [2013]   [Jun]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [ 102/127] iommu/amd: Workaround for ERBT1312
Hello Joerg,

Joerg Roedel wrote:
> Hi Andreas,
>
> On Fri, Jun 28, 2013 at 06:11:36PM +0200, Andreas Hartmann wrote:
>> Hello Joerg, hello Alex,
>>
>> the subsequent patch and the patch "iommu/amd: Re-enable IOMMU event log
>> interrupt after handling." 925fe08bce38d1ff052fe2209b9e2b8d5fbb7f98
>> spread /var/log/messages with the following line (> 700 lines/second)
>> right after loading vfio:
>>
>> AMD-Vi: Event logged [IO_PAGE_FAULT device=00:14.0 domain=0x0000 address=0x000000fdf9103300 flags=0x0600]
>>
>> lspci -vvvs 0:14.0
>> 00:14.0 SMBus: Advanced Micro Devices [AMD] nee ATI SBx00 SMBus Controller (rev 42)
>> Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+
>> Status: Cap- 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
>
> Most likely a BIOS issue that is uncovered by re-enabling the event-log
> interrupt patch. The device itself is only used by the BIOS and not by
> the Linux kernel

Thanks for this info! Good to know.

[...]

>> I removed the two mentioned patches and all is working
>> fine again as before.
>
> Without these two patches, can you check dmesg after boot if there are
> other lines which report IO_PAGE_FAULTs?

You're right, there is exactly one entry directly after loading of vfio.
I can see this message, too, with linux 3.4.43.


Regards,
Andreas


\
 
 \ /
  Last update: 2013-06-28 21:01    [W:0.061 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site