lkml.org 
[lkml]   [2013]   [Jun]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/4] watchdog: at91sam9_wdt: update device tree doc
Date
Add new at91sam9 watchdog properties to the documentation.

Signed-off-by: Boris BREZILLON <b.brezillon@overkiz.com>
---
.../devicetree/bindings/watchdog/atmel-wdt.txt | 30 ++++++++++++++++++--
1 file changed, 28 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt b/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt
index fcdd48f..e043106 100644
--- a/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt
+++ b/Documentation/devicetree/bindings/watchdog/atmel-wdt.txt
@@ -9,11 +9,37 @@ Required properties:

Optional properties:
- timeout-sec: contains the watchdog timeout in seconds.
+- interrupts : Should contain WDT interrupt.
+- atmel,max-heartbeat-sec : Should contain the maximum heartbeat value in
+ seconds. This value should be less than 16. It is used to compute the
+ WDV field.
+- atmel,min-heartbeat-sec : Should contain the minimum heartbeat value in
+ seconds. This value should be less than 4 times the max-heartbeat-sec
+ value. It is used to compute the WDD field.
+- atmel,watchdog-type : Should be "hardware" or "software". Hardware watchdog
+ use the at91 watchdog reset. Software watchdog use the watchdog
+ interrupt to trigger a software reset.
+- atmel,reset-type : Should be "proc" or "all".
+ "all" : assert peripherals and processor reset signals
+ "proc" : assert the processor reset signal
+ This is valid only when using "hardware" watchdog.
+- atmel,disable : Should be present if you want to disable the watchdog.
+- atmel,idle-halt : Should be present if you want to stop the watchdog when
+ entering idle state.
+- atmel,dbg-halt : Should be present if you want to stop the watchdog when
+ entering debug state.

Example:
-
watchdog@fffffd40 {
compatible = "atmel,at91sam9260-wdt";
reg = <0xfffffd40 0x10>;
- timeout-sec = <10>;
+ interrupts = <1 IRQ_TYPE_LEVEL_HIGH 7>;
+ timeout-sec = <15>;
+ atmel,watchdog-type = "hardware";
+ atmel,reset-type = "all";
+ atmel,dbg-halt;
+ atmel,idle-halt;
+ atmel,max-heartbeat-sec = <16>;
+ atmel,min-heartbeat-sec = <0>;
+ status = "okay";
};
--
1.7.9.5


\
 
 \ /
  Last update: 2013-06-21 10:21    [W:0.079 / U:5.868 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site