lkml.org 
[lkml]   [2013]   [Jun]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] pinctrl: abx500: fix abx500_gpio_get()
Hi Patrice,

On Thu, Jun 20, 2013 at 09:24:44AM +0200, patrice.chotard.st@gmail.com wrote:
> From: Patrice Chotard <patrice.chotard@st.com>
>
> _ allow to get output GPIO value.
> _ as there is no GPIO0 on ABX500, use correct offset with
> abx500_gpio_get_bit().
>
> Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
> ---
> drivers/pinctrl/pinctrl-abx500.c | 16 ++++++++++++++--
> 1 file changed, 14 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pinctrl/pinctrl-abx500.c b/drivers/pinctrl/pinctrl-abx500.c
> index 4307b0f..070442d 100644
> --- a/drivers/pinctrl/pinctrl-abx500.c
> +++ b/drivers/pinctrl/pinctrl-abx500.c
> @@ -162,10 +162,22 @@ static int abx500_gpio_get(struct gpio_chip *chip, unsigned offset)
> {
> struct abx500_pinctrl *pct = to_abx500_pinctrl(chip);
> bool bit;
> + bool is_out;
> + u8 gpio_offset = offset - 1;
> int ret;
>
> - ret = abx500_gpio_get_bit(chip, AB8500_GPIO_IN1_REG,
> - offset, &bit);
> + ret = abx500_gpio_get_bit(chip, AB8500_GPIO_DIR1_REG, gpio_offset, &is_out);
> + if (ret < 0) {
> + dev_err(pct->dev, "%s failed\n", __func__);
> + return ret;
> + }
> +
> + if (is_out)
> + ret = abx500_gpio_get_bit(chip, AB8500_GPIO_OUT1_REG,
> + gpio_offset, &bit);
> + else
> + ret = abx500_gpio_get_bit(chip, AB8500_GPIO_IN1_REG,
> + gpio_offset, &bit);

Why would you want to read the pin state from the output register? The
input one should be the one that reflect the real electrical value of
the pin, and I think it may be useful to detect some fault condition
too... Is there a specific reasion to use the output register instead?

Thanks,
Fabio

> if (ret < 0) {
> dev_err(pct->dev, "%s failed\n", __func__);
> return ret;
> --
> 1.7.10
>

--
Fabio Baltieri


\
 
 \ /
  Last update: 2013-06-20 11:41    [W:0.071 / U:0.560 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site