lkml.org 
[lkml]   [2013]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH V2] ARM: EXYNOS: Fix hotplug when CPUs boot in HYP mode
On 08/05/13 13:23, Giridhar Maruthy wrote:
> On 7 May 2013 14:25, Marc Zyngier <marc.zyngier@arm.com> wrote:
>> On 07/05/13 06:54, Giridhar Maruthy wrote:
>>> This patch is a modification from the Christoffer Dall's u-boot
>>> patch. This is required to put the secondary processors in hyp
>>> mode during cpu hotplug when u-boot is no longer alive.
>>>
>>> Marc Zyngier suggested this logic to go into firmware or, u-boot
>>> putting a trampoline code into a page /memreserve/d by DT. But
>>> this seemed to have a problem. Once the cpu is hotplugged in
>>> runtime, the control is in ROM code and waits for event.
>>> Kernel provides a return address in kernel to which the processor
>>> jumps once it gets an event. If the control branches to the
>>> trampoline code here, this trampoline code has no kernel return
>>> address.
>>>
>>> Someone with better logic or better placement of this logic
>>> elsewhere is welcome.
>>
>> What prevents you from writing the kernel address in the memreserved
>> page? Some obvious location, like the last word of the page? You only
>> have to do it once (from the boot CPU, for example).
>>
>> Or did I miss something else?
>
> Thanks Marc, I think I understand now.
>
> I guess I also need to put the primary cpu boot mode into a temporary location.

Indeed. You'll need that for your secondaries to enter in the same mode
as the primary.

M.
--
Jazz is not dead. It just smells funny...



\
 
 \ /
  Last update: 2013-05-08 15:21    [W:0.040 / U:1.252 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site