lkml.org 
[lkml]   [2013]   [May]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Freescale P1022 SoC hangs when initializing USB
On Fri, 24 May 2013 14:42:46 +0000
"Thumshirn, Johannes Tobias" <Johannes.Thumshirn@men.de> wrote:

> Hi list,
>
> I'm experiencing problems while booting on a Freescale P1013 based board. It hangs on USB initialization:
> [ 3.763584] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
> [ 3.770519] ehci-pci: EHCI PCI platform driver
> [ 3.775116] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
> [ 3.781972] fsl-ehci fsl-ehci.0: Freescale On-Chip EHCI Host Controller
> [ 3.788812] fsl-ehci fsl-ehci.0: new USB bus registered, assigned bus number 1
>
> The corresponding device-tree:
> usb@22000 {
> #address-cells = <1>;
> #size-cells = <0>;
> compatible = "fsl-usb2-dr";
> reg = <0x22000 0x1000>;
> interrupt-parent = <&mpic>;
> interrupts = <28 0x2 0 0>;
> phy_type = "ulpi";
> };
>
> usb@23000 {
> #address-cells = <1>;
> #size-cells = <0>;
> compatible = "fsl-usb2-dr";
> reg = <0x23000 0x1000>;
> interrupt-parent = <&mpic>;
> interrupts = <46 0x2 0 0>;
> phy_type = "ulpi";
> };

please change compatible property in both nodes to

compatible = "fsl-usb2-dr-v1.6", "fsl-usb2-dr";

and try again to see if it helps.

Thanks,

Anatolij


\
 
 \ /
  Last update: 2013-05-24 19:41    [W:0.044 / U:0.180 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site