lkml.org 
[lkml]   [2013]   [Mar]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] ARM: timer: Shutdown clock event device when stopping local timer
From
2013/3/30 Russell King - ARM Linux <linux@arm.linux.org.uk>:
> On Sat, Mar 30, 2013 at 05:57:38PM +0800, Ning Jiang wrote:
>> 2013/3/30 Stephen Boyd <sboyd@codeaurora.org>:
>> > On 03/29/13 02:24, ning.n.jiang@gmail.com wrote:
>> >> From: Ning Jiang <ning.n.jiang@gmail.com>
>> >>
>> >> Currently there are two problems when we try to stop local timer.
>> >> First, it calls set_mode function directly so mode state is not
>> >> updated for the clock event device. Second, it makes the device
>> >> unused instead of shutdown.
>> >
>> > What device is this a problem on? I believe this only matters to drivers
>> > which enable their timer in their set_next_event() callback? But even
>> > then, does anything actually happen because the interrupt should have
>> > been disabled in the local timer stop callback.
>> >
>>
>> Right. Drivers which enable timer in set_next_event() will have this problem.
>> It will not have functional problem in my case. But my device cannot enter
>> low power mode with a pending interrupt even if it is disabled.
>
> You're not telling us what you have discovered. How does set_next_event()
> get called after we've set the mode to UNUSED in the current code?

In the current code we did not set the mode to UNUSED but only call
set_mode callback function for the clock event device. This normally
disables current clock event device. The dying CPU eventually will
switch to idle thread, call tick_nohz_idle_enter(), try to cancel the
sched_timer and reprogram the next event. Then set_next_event() gets
called. The call stack will be like:

tick_nohz_idle_enter
-> __tick_nohz_idle_enter
-> tick_nohz_stop_sched_tick
-> hrtimer_cancel
-> hrtimer_try_to_cancel
-> remove_hrtimer
-> __remove_hrtimer
-> hrtimer_force_reprogram
-> tick_program_event
-> clockevents_program_event
-> set_next_event

In set_next_event() we'll re-enable and re-program the clock event device.


\
 
 \ /
  Last update: 2013-03-30 13:41    [W:0.059 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site