Messages in this thread Patch in this message | | | From | jjhiblot@traphand ... | Subject | [PATCH 5/6] at91: dt: sam9261: Add an entry in the DT for the SMC/EBI bus driver. | Date | Tue, 31 Dec 2013 17:32:13 +0100 |
| |
From: jean-jacques hiblot <jean-jacques.hiblot@jdsu.com>
This patch creates a new entry in the device tree for the 9261 under which should be the devices attached to the EBI. It also moves the NAND DT entries under this new bus.
Signed-off-by: Jean-Jacques Hiblot <jjhiblot@traphandler.com> --- arch/arm/boot/dts/at91sam9261.dtsi | 32 +++++++++++++++++--------- arch/arm/boot/dts/at91sam9261ek.dts | 46 ++++++++++++++++++++++++++++--------- 2 files changed, 56 insertions(+), 22 deletions(-)
diff --git a/arch/arm/boot/dts/at91sam9261.dtsi b/arch/arm/boot/dts/at91sam9261.dtsi index 925f9ad..acd19b4 100644 --- a/arch/arm/boot/dts/at91sam9261.dtsi +++ b/arch/arm/boot/dts/at91sam9261.dtsi @@ -525,21 +525,31 @@ status = "disabled"; }; - nand0: nand@40000000 { - compatible = "atmel,at91rm9200-nand"; + smc: smc@ffffec00 { #address-cells = <1>; #size-cells = <1>; - reg = <0x40000000 0x10000000>; - atmel,nand-addr-offset = <22>; - atmel,nand-cmd-offset = <21>; + compatible = "atmel,at91sam9261-smc"; + reg = <0xffffec00 0x80>; pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_nand>; - - gpios = <&pioC 15 GPIO_ACTIVE_HIGH - &pioC 14 GPIO_ACTIVE_HIGH - 0 - >; status = "disabled"; + ranges = < >; + nand0: nand@40000000 { + compatible = "atmel,at91rm9200-nand"; + #address-cells = <1>; + #size-cells = <1>; + reg = <0x40000000 0x10000000>; + atmel,nand-addr-offset = <22>; + atmel,nand-cmd-offset = <21>; + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_nand>, <&pinctrl_smc_nandoe>, <&pinctrl_smc_nandwe>; + smc,cs = <3>; + + gpios = <&pioC 15 GPIO_ACTIVE_HIGH + &pioC 14 GPIO_ACTIVE_HIGH + 0 + >; + status = "disabled"; + }; }; usb0: ohci@00500000 { diff --git a/arch/arm/boot/dts/at91sam9261ek.dts b/arch/arm/boot/dts/at91sam9261ek.dts index 03c05fc..11cf619 100644 --- a/arch/arm/boot/dts/at91sam9261ek.dts +++ b/arch/arm/boot/dts/at91sam9261ek.dts @@ -42,17 +42,6 @@ }; }; - nand0: nand@40000000 { - nand-bus-width = <8>; - nand-ecc-mode = "soft"; - nand-on-flash-bbt = <1>; - status = "okay"; - at91bootstrap@0 { - label = "at91bootstrap"; - reg = <0x0 0x20000>; - }; - }; - fb0: fb@0x00600000 { display = <&display0>; status = "okay"; @@ -83,6 +72,41 @@ }; }; }; + + smc: smc@ffffec00 { + status = "okay"; + + nand0: nand@40000000 { + nand-bus-width = <8>; + nand-ecc-mode = "soft"; + nand-on-flash-bbt = <1>; + status = "okay"; + + smc,ncs_read_setup = <0>; + smc,nrd_setup = <1>; + smc,ncs_write_setup = <0>; + smc,nwe_setup = <1>; + smc,ncs_read_pulse = <3>; + smc,nrd_pulse = <3>; + smc,ncs_write_pulse = <3>; + smc,nwe_pulse = <3>; + smc,read_cycle = <5>; + smc,write_cycle = <5>; + smc,tdf_cycles = <2>; + smc,tdf_optimized = <0>; + smc,page_size = <0>; + smc,byte_access_type = <0>; + smc,bus_width = <0>; + smc,nwait_mode = <0>; + smc,read_mode = <1>; + smc,write_mode = <1>; + + at91bootstrap@0 { + label = "at91bootstrap"; + reg = <0x0 0x20000>; + }; + }; + }; }; leds { -- 1.8.4.2
| |