lkml.org 
[lkml]   [2013]   [Nov]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: [PATCH 2/2] memory: ti-aemif: add bindings for AEMIF driver
    > +				the chip select signal.
    > + Minimum value is 1 (0 treated as 1).
    > +
    > +- ti,cs-wsetup: write setup width, ns
    > + Time between the beginning of a memory cycle
    > + and the activation of write strobe.
    > + Minimum value is 1 (0 treated as 1).
    > +
    > +- ti,cs-wstrobe: write strobe width, ns
    > + Time between the activation and deactivation of
    > + the write strobe.
    > + Minimum value is 1 (0 treated as 1).
    > +
    > +- ti,cs-whold: write hold width, ns
    > + Time between the deactivation of the write
    > + strobe and the end of the cycle (which may be
    > + either an address change or the deactivation of
    > + the chip select signal.
    > + Minimum value is 1 (0 treated as 1).
    > +
    > +If any of the above parameters are absent, current parameter value will be taken
    > +from the corresponding HW reg.
    > +
    > +The name for cs node must be in format csN, where N is the cs number.

    this is wired we should use reg instead to represent the cs as done for SPI
    or a an other property

    Best Regards,
    J.


    \
     
     \ /
      Last update: 2013-11-20 20:01    [W:2.762 / U:0.200 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site