lkml.org 
[lkml]   [2013]   [Oct]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 3/3] i2c: xilinx: Use devm_* functions
On 10/04/2013 01:58 PM, Wolfram Sang wrote:
> On Fri, Oct 04, 2013 at 11:16:20AM +0200, Michal Simek wrote:
>> On 10/04/2013 07:33 AM, Wolfram Sang wrote:
>>>
>>>> + i2c->base = devm_ioremap_resource(&pdev->dev, res);
>>>> + if (IS_ERR(i2c->base)) {
>>>> + dev_err(&pdev->dev, "Could not allocate iomem\n");
>>>
>>> devm_ioremap_resource already prints error messages.
>>
>> you are right.
>>
>>>
>>>> + ret = devm_request_irq(&pdev->dev, irq, xiic_isr, 0, pdev->name, i2c);
>>>
>>> This is too early. Can you find out why?
>>
>> Why do you think that it is too early?
>
> The ISR uses spinlocks which are not initialized by then.

And waitqueue too. Ok I will keep that request irq in current location
and I will add xiic_reinit() below this code.

>> I am looking at origin code again and I think that the code
>> is also problematic because in xiic_reinit() interrupts are enabled
>> but they are requested later.
>> Shouldn't be there a logic that interrupts should be enabled when
>> interrupts are registered by the kernel?
>
> First register the handler, then activate interrupts. You are right,
> this needs to be fixed, too.

Do you want me to create separate patch just about moving request irq in front of
xiic_reinit()? And then devm_ conversion?

Thanks,
Michal

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2013-10-04 14:21    [W:0.538 / U:0.736 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site