Messages in this thread | | | Date | Fri, 11 Oct 2013 12:57:37 +0200 | Subject | Re: [PATCH] gpio/lynxpoint: check if the interrupt is enabled in IRQ handler | From | Linus Walleij <> |
| |
On Tue, Oct 1, 2013 at 4:35 PM, Mika Westerberg <mika.westerberg@linux.intel.com> wrote:
> Checking LP_INT_STAT is not enough in the interrupt handler because its > contents get updated regardless of whether the pin has interrupt enabled or > not. This causes the driver to loop forever for GPIOs that are pulled up. > > Fix this by checking the interrupt enable bit for the pin as well. > > Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Patch applied for fixes with Mathias ACK.
Should this be tagged for -stable as well?
Yours, Linus Walleij
| |