lkml.org 
[lkml]   [2013]   [Oct]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] omapdss: Add new panel driver for Topolly td028ttec1 LCD.
On 10/10/2013 02:13 PM, Tomi Valkeinen wrote:
> On 10/10/13 14:52, Dr. H. Nikolaus Schaller wrote:
>
>> Yes, I agree and I am willing to help if someone comes up with such a SoC.
>> At the moment we have connected it to the OMAP3 only.
>
> True, but even without that kind of SoC, SPI bitbanging should be
> handled by an SPI driver, not by the drivers that use the bus.
>
>> I.e. I want not to do a lot of work for others who we just guess about that they
>> might exist...
>
> Yep. It's fine for me, it's not that much extra code in the panel driver.
>
>>> The panel hardware has three wires, so the panel driver (if it does
>>> handle the bus by bitbanging) can only refer to three gpios.
>>
>> Hm. The panle hardware has 3 but the SoC (OMAP3) the driver
>> is running on has 4.
>
> Right, but this panel driver is a driver for the panel hardware. Not for
> the SoC, or the SoC+panel combination. So the panel driver must only use
> resources as seen by the panel hardware.
>
>>> So either
>>> the bus details should be hidden by using the normal spi framework, or
>>> if the driver does the bitbanging, use the gpios as specified in the
>>> panel spec. The panel driver cannot contain any board specific stuff.
>>
>> The bitbang driver shown below can handle either 3 or 4 gpios (except
>> for initialization).
>
> It's not a bitbang driver, it's a panel driver. And anyway, if I
> understood right, your use of 4 gpios was just a hack to try to make it
> look like a normal 4-wire SPI bus. What you really have is 3 wires, 3
> gpios. I don't see any reason to use 4 gpios, as two of them are the same.
>
> Hmm, how does it work anyway. Did I understand it right, the panel's
> 'DIN' pin is connected to two gpios on the SoC, and one of those gpios
> is set as output, and the other as input? So the SoC is always pulling
> that line up or down, and the panel is also pulling it up or down when
> it's sending data. I'm no HW guy but that sounds quite bad =).
>
> I've never written or studied a bitbanging driver, but shouldn't there
> be just one gpio used on the SoC for DIN, and it would be set to either
> output or input mode, depending on if we are reading or writing?

Back in the OpenMoko days we used the panel in normal 4-wire SPI mode with
the GPIO bitbang SPI master. The bitbang code in this driver also looks like
normal 4 wire.

- Lars



\
 
 \ /
  Last update: 2013-10-10 15:01    [W:0.183 / U:0.464 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site