lkml.org 
[lkml]   [2013]   [Oct]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/4] i2c: busses: i2c-st: Add ST I2C controller
On 10/01/2013 04:39 AM, Maxime COQUELIN wrote:
> This patch adds support to SSC (Synchronous Serial Controller)
> I2C driver. This IP also supports SPI protocol, but this is not
> the aim of this driver.
>
> This IP is embedded in all ST SoCs for Set-top box platorms, and
> supports I2C Standard and Fast modes.

> diff --git a/Documentation/devicetree/bindings/i2c/i2c-st.txt b/Documentation/devicetree/bindings/i2c/i2c-st.txt

> +Required properties :

> +- clocks : phandle to the I2C clock source
> +- clock-names : from common clock binding: Shall be "ssc"

I'd prefer to define that as:

clock-names: Must contain "ssc".
clocks: Must contain an entry for each name in clock-names. See the
common clock bindings.

That way, it makes it clear that clock-names is the primary lookup
mechanism, rather than some auxiliary documentation.

> +Recommended properties :
> +- clock-frequency : Desired I2C bus clock frequency in Hz. Otherwise

s/Otherwise/If not specified,/

> + the default 100 kHz frequency will be used. As only Normal and Fast modes
> + are supported, possible values are 100000 and 400000.

I think that's just optional. Since there's a well-defined sensible
default, there's no need to recommend it.

> +Optional properties :
> +- i2c-min-scl-pulse-width-us : The minimum valid SCL pulse width that is allowed
> + through the deglitch circuit. In units of us.
> +- i2c-min-sda-pulse-width-us : The minimum valid SDA pulse width that is allowed
> + through the deglitch circuit. In units of us.

Are those properties specific to this binding, or intended to be
generic? If specific to this binding, a vendor prefix should be present
in the property name. If not, you probably want to document the
properties in some common file.

> +Examples :

s/Examples/Example/ since there's just one.

> +i2c0: i2c@fed40000 {
> + compatible = "st,comms-ssc-i2c";
> + reg = <0xfed40000 0x110>;
> + interrupts = <GIC_SPI 187 IRQ_TYPE_EDGE_RISING>;
> + clocks = <&CLK_S_ICN_REG_0>;
> + clock-names = "ssc";
> + clock-frequency = <400000>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_i2c0_default>;

That wasn't mentioned in the binding definition. You'd probably want to
document the requirement for those two properties by saying something like:

A pinctrl state named "default" must be defined, using the bindings in
../pinctrl/pinctrl-binding.txt.


\
 
 \ /
  Last update: 2013-10-02 01:41    [W:0.066 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site