lkml.org 
[lkml]   [2013]   [Jan]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v9 03/20] mfd: omap-usb-tll: Fix channel count detection
Date
Fix channel count detecion for REV2. Also, don't give up
if we don't recognize the IP Revision. We assume the default
number of channels (i.e. 3) for unrecognized IPs.

Signed-off-by: Roger Quadros <rogerq@ti.com>
Reviewed-by: Felipe Balbi <balbi@ti.com>
---
drivers/mfd/omap-usb-tll.c | 20 +++++++++++---------
1 files changed, 11 insertions(+), 9 deletions(-)

diff --git a/drivers/mfd/omap-usb-tll.c b/drivers/mfd/omap-usb-tll.c
index e459489..9658e18 100644
--- a/drivers/mfd/omap-usb-tll.c
+++ b/drivers/mfd/omap-usb-tll.c
@@ -98,6 +98,7 @@
struct usbtll_omap {
struct clk *usbtll_p1_fck;
struct clk *usbtll_p2_fck;
+ int nch; /* num. of channels */
struct usbhs_omap_platform_data *pdata;
/* secure the register updates */
spinlock_t lock;
@@ -210,7 +211,7 @@ static int usbtll_omap_probe(struct platform_device *pdev)
unsigned reg;
unsigned long flags;
int ret = 0;
- int i, ver, count;
+ int i, ver;

dev_dbg(dev, "starting TI HSUSB TLL Controller\n");

@@ -262,16 +263,18 @@ static int usbtll_omap_probe(struct platform_device *pdev)
ver = usbtll_read(base, OMAP_USBTLL_REVISION);
switch (ver) {
case OMAP_USBTLL_REV1:
- case OMAP_USBTLL_REV2:
- count = OMAP_TLL_CHANNEL_COUNT;
+ tll->nch = OMAP_TLL_CHANNEL_COUNT;
break;
+ case OMAP_USBTLL_REV2:
case OMAP_USBTLL_REV3:
- count = OMAP_REV2_TLL_CHANNEL_COUNT;
+ tll->nch = OMAP_REV2_TLL_CHANNEL_COUNT;
break;
default:
- dev_err(dev, "TLL version failed\n");
- ret = -ENODEV;
- goto err_ioremap;
+ tll->nch = OMAP_TLL_CHANNEL_COUNT;
+ dev_dbg(dev,
+ "USB TLL Rev : 0x%x not recognized, assuming %d channels\n",
+ ver, tll->nch);
+ break;
}

if (is_ehci_tll_mode(pdata->port_mode[0]) ||
@@ -291,7 +294,7 @@ static int usbtll_omap_probe(struct platform_device *pdev)
usbtll_write(base, OMAP_TLL_SHARED_CONF, reg);

/* Enable channels now */
- for (i = 0; i < count; i++) {
+ for (i = 0; i < tll->nch; i++) {
reg = usbtll_read(base, OMAP_TLL_CHANNEL_CONF(i));

if (is_ohci_port(pdata->port_mode[i])) {
@@ -319,7 +322,6 @@ static int usbtll_omap_probe(struct platform_device *pdev)
}
}

-err_ioremap:
spin_unlock_irqrestore(&tll->lock, flags);
iounmap(base);
pm_runtime_put_sync(dev);
--
1.7.4.1


\
 
 \ /
  Last update: 2013-01-23 16:21    [W:0.165 / U:0.428 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site