lkml.org 
[lkml]   [2012]   [Sep]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v6 1/4] Runtime Interpreted Power Sequences
On 09/13/2012 01:08 AM, Alex Courbot wrote:
> On Thursday 13 September 2012 14:54:09 Tomi Valkeinen wrote:
>> * PGP Signed by an unknown key
>>
>> On Thu, 2012-09-13 at 15:36 +0900, Alex Courbot wrote:
>>
>>> On Thursday 13 September 2012 14:22:57 Tomi Valkeinen wrote:
>>>
>>>
>>>
>>>> However, I fear these board specific things may be quite a bit
>>>> anything,
>>>> so it may well be pwm, gpios and regulators are not enough for them.
>>>> For
>>>> example, there could be an FPGA on the board which requires some
>>>> configuration to accomplish the task at hand. It could be rather
>>>> difficult to handle it with a generic power sequence.
>>>
>>>
>>> Right. Note that this framework is supposed to be extended - I would like
>>> to at least add regulator voltage setting, and maybe even support for
>>> clocks and pinmux (but that might be out of place).
>>
>>
>> Yes, that's one concern of mine... I already can imagine someone
>> suggesting adding conditionals to the power sequence data.
>
> I took care of that when naming the feature - it is not a "sequence" anymore
> if you have conditionals. :P
>
>> Perhaps also
>> direct memory read/writes so you can twiddle registers directly. And so
>> on. Where's the limit what it should contain? Can we soon write full
>> drivers with the DT data? =)
>
> I shall be satisfied the day the kernel is released as one big DT node along
> with the 5KB interpreter that runs it.

I know you're joking, but *cough* OpenFirmware *cough*, right?


\
 
 \ /
  Last update: 2012-09-13 18:21    [W:0.094 / U:8.764 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site