lkml.org 
[lkml]   [2012]   [Aug]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: O_DIRECT to md raid 6 is slow
On 08/17/2012 09:31 AM, Stan Hoeppner wrote:
> On 8/16/2012 4:50 PM, Miquel van Smoorenburg wrote:
>> I did a simple test:
>>
>> * created a 1G partition on 3 seperate disks
>> * created a md raid5 array with 512K chunksize:
>> mdadm -C /dev/md0 -l 5 -c $((1024*512)) -n 3 /dev/sdb1 /dev/sdc1
>> /dev/sdd1
>> * ran disk monitoring using 'iostat -k 5 /dev/sdb1 /dev/sdc1 /dev/sdd1'
>> * wrote a single 4K block:
>> dd if=/dev/zero bs=4K count=1 oflag=direct seek=30 of=/dev/md0
>>
>> Output from iostat over the period in which the 4K write was done. Look
>> at kB read and kB written:
>>
>> Device: tps kB_read/s kB_wrtn/s kB_read kB_wrtn
>> sdb1 0.60 0.00 1.60 0 8
>> sdc1 0.60 0.80 0.80 4 4
>> sdd1 0.60 0.00 1.60 0 8
>>
>> As you can see, a single 4K read, and a few writes. You see a few blocks
>> more written that you'd expect because the superblock is updated too.
>
> I'm no dd expert, but this looks like you're simply writing a 4KB block
> to a new stripe, using an offset, but not to an existing stripe, as the
> array is in a virgin state. So it doesn't appear this test is going to
> trigger RMW. Don't you need now need to do another write in the same
> stripe to to trigger RMW? Maybe I'm just reading this wrong.

That shouldn't matter, but that is easily checked ofcourse, by writing
some random random data first, then doing the dd 4K write also with
random data somewhere in the same area:

# dd if=/dev/urandom bs=1M count=3 of=/dev/md0
3+0 records in
3+0 records out
3145728 bytes (3.1 MB) copied, 0.794494 s, 4.0 MB/s

Now the first 6 chunks are filled with random data, let write 4K
somewhere in there:

# dd if=/dev/urandom bs=4k count=1 seek=25 of=/dev/md0
1+0 records in
1+0 records out
4096 bytes (4.1 kB) copied, 0.10149 s, 40.4 kB/s

Output from iostat over the period in which the 4K write was done:

Device: tps kB_read/s kB_wrtn/s kB_read kB_wrtn
sdb1 0.60 0.00 1.60 0 8
sdc1 0.60 0.80 0.80 4 4
sdd1 0.60 0.00 1.60 0 8

Mike.


\
 
 \ /
  Last update: 2012-08-17 14:01    [W:1.311 / U:0.276 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site