lkml.org 
[lkml]   [2012]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCHv6 5/8] kvm: eoi msi documentation
On Sun, Jun 03, 2012 at 10:28:21AM +0300, Michael S. Tsirkin wrote:
> Document the new EOI MSR. Couldn't decide whether this change belongs
> conceptually on guest or host side, so a separate patch.
>
> Signed-off-by: Michael S. Tsirkin <mst@redhat.com>
> ---
> Documentation/virtual/kvm/msr.txt | 32 ++++++++++++++++++++++++++++++++
> 1 files changed, 32 insertions(+), 0 deletions(-)
>
> diff --git a/Documentation/virtual/kvm/msr.txt b/Documentation/virtual/kvm/msr.txt
> index 96b41bd..f202a22 100644
> --- a/Documentation/virtual/kvm/msr.txt
> +++ b/Documentation/virtual/kvm/msr.txt
> @@ -223,3 +223,35 @@ MSR_KVM_STEAL_TIME: 0x4b564d03
> steal: the amount of time in which this vCPU did not run, in
> nanoseconds. Time during which the vcpu is idle, will not be
> reported as steal time.
> +
> +MSR_KVM_EOI_EN: 0x4b564d04
> + data: Bit 0 is 1 when PV end of interrupt is enabled on the vcpu; 0
> + when disabled. When enabled, bits 63-1 hold 2-byte aligned physical address
> + of a 2 byte memory area which must be in guest RAM and must be zeroed.
> +
> + The first, least significant bit of 2 byte memory location will be
> + written to by the hypervisor, typically at the time of interrupt
> + injection. Value of 1 means that guest can skip writing EOI to the apic
> + (using MSR or MMIO write); instead, it is sufficient to signal
> + EOI by clearing the bit in guest memory - this location will
> + later be polled by the hypervisor.
> + Value of 0 means that the EOI write is required.
> +
> + It is always safe for the guest to ignore the optimization and perform
> + the APIC EOI write anyway.
> +
> + Hypervisor is guaranteed to only modify this least
> + significant bit while in the current VCPU context, this means that
> + guest does not need to use either lock prefix or memory ordering
> + primitives to synchronise with the hypervisor.
> +
> + However, hypervisor can set and clear this memory bit at any time:
> + therefore to make sure hypervisor does not interrupt the
> + guest and clear the least significant bit in the memory area
> + in the window between guest testing it to detect
> + whether it can skip EOI apic write and between guest
> + clearing it to signal EOI to the hypervisor,
> + guest must both read the least sgnificant bit in the memory area and

typo

> + clear it using a single CPU instruction, such as test and clear, or
> + compare and exchange.
> +
> --



\
 
 \ /
  Last update: 2012-06-13 04:41    [W:0.814 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site