[lkml]   [2012]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRE: [PATCH 3/3] arch/tile: tilegx PCI root complex support
Bjorn Helgaas wrote:
> Can this be done with the generic pcie_bus_configure_settings() or is
> there something tilegx-specific about this?
> If at all possible, you should use pci_scan_root_bus() here instead,
> so you can tell PCI what the host bridge apertures are.

I've been exchanging email with the author of this driver during the week (he's based out of the California office, and I'm in Massachusetts) and the two suggestions quoted above still need further investigation before we can get back to you. I'm out next week for spring school break so it won't be until the following week that I'll put out a v2 of this patch. The other comments (not quoted) we've already incorporated into the driver.

So thanks a lot for your feedback!

Chris Metcalf
Tilera Corp.

 \ /
  Last update: 2012-04-16 01:15    [W:0.095 / U:3.008 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site