lkml.org 
[lkml]   [2012]   [Dec]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/3] mmc: sdhci: check voltage range only on regulators aware of voltage value
Date
Some regulators don't report any voltage values, so checking supported
voltage range results in disabling all SDHCI_CAN_VDD_* flags and
registration failure. This patch finally provides a correct fix for the
registration of SDHCI driver with all possible voltage regulators:
dummy, fixed and regulated without using regulator_count_voltages()
hacks.

Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
---
drivers/mmc/host/sdhci.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index a9ad2cd..d244dc0 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2930,7 +2930,11 @@ int sdhci_add_host(struct sdhci_host *host)
}

#ifdef CONFIG_REGULATOR
- if (host->vmmc && regulator_count_voltages(host->vmmc) > 1) {
+ /*
+ * Voltage range check makes sense only if regulator reports
+ * any voltage value.
+ */
+ if (host->vmmc && regulator_get_voltage(host->vmmc) > 0) {
ret = regulator_is_supported_voltage(host->vmmc, 2700000,
3600000);
if ((ret <= 0) || (!(caps[0] & SDHCI_CAN_VDD_330)))
--
1.7.9.5


\
 
 \ /
  Last update: 2012-12-05 09:21    [W:0.092 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site