lkml.org 
[lkml]   [2012]   [Nov]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Subject[PATCH] Enable hardware breakpoint upon re-registering
From
Date
On powerpc, ptrace will disable hardware breakpoint request once the
breakpoint is hit. It is the responsibility of the caller to set it
again. However, when the caller sets the hardware breakpoint again
using ptrace(PTRACE_SET_DEBUGREG, child_pid, 0, addr), the hardware
breakpoint is not enabled.

While gdb's approach is to unregister and re-register the hardware
breakpoint every time the breakpoint is hit - which is working fine,
this could affect other programs trying to re-register hardware
breakpoint without unregistering.

This patch enables hardware breakpoint if the caller is re-registering.

Signed-off-by: Aravinda Prasad <aravinda@linux.vnet.ibm.com>
---
arch/powerpc/kernel/ptrace.c | 4 ++++
1 files changed, 4 insertions(+), 0 deletions(-)

diff --git a/arch/powerpc/kernel/ptrace.c b/arch/powerpc/kernel/ptrace.c
index 79d8e56..09371d0 100644
--- a/arch/powerpc/kernel/ptrace.c
+++ b/arch/powerpc/kernel/ptrace.c
@@ -952,6 +952,10 @@ int ptrace_set_debugreg(struct task_struct *task, unsigned long addr,
arch_bp_generic_fields(data &
(DABR_DATA_WRITE | DABR_DATA_READ),
&attr.bp_type);
+
+ /* Enable breakpoint */
+ attr.disabled = false;
+
ret = modify_user_hw_breakpoint(bp, &attr);
if (ret) {
ptrace_put_breakpoints(task);


\
 
 \ /
  Last update: 2012-11-05 09:42    [W:0.034 / U:0.176 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site