Messages in this thread | | | Subject | Re: [E1000-devel] e1000e: NIC not working (after resume?) | From | Frederik Himpe <> | Date | Fri, 09 Sep 2011 23:43:32 +0200 |
| |
On Fri, 2011-09-09 at 23:05 +0200, Frederik Himpe wrote:
> Full syslog (221 KB) is at > http://artipc10.vub.ac.be/~frederik/e1000e/syslog > > This is what happened: > * 21:33:11: cold boot, network cable plugged in, network working fine > * 21:35:24: start suspend to ram > * 21:35:40: resume system, e1000e network working fine (however, wlan > now refuses to connect, but I have not investigated that, not sure if > whether this might be related or not) > * 21:52:44: logs are filled up with an endless loop of these messages (I > think I disconnected the network cable at that time: > > Sep 9 21:52:44 defected kernel: [ 1188.440061] ehci_hcd 0000:00:1d.7: BAR 0: set to [mem 0xfed1c000-0xfed1c3ff] (PCI address [0xfed1c000-0xfed1c3ff]) > Sep 9 21:52:44 defected kernel: [ 1188.440097] ehci_hcd 0000:00:1d.7: restoring config space at offset 0xf (was 0x100, writing 0x104) > Sep 9 21:52:44 defected kernel: [ 1188.440137] ehci_hcd 0000:00:1d.7: restoring config space at offset 0x1 (was 0x2900000, writing 0x2900102) > Sep 9 21:52:44 defected kernel: [ 1188.447422] ehci_hcd 0000:00:1d.7: PME# disabled > Sep 9 21:52:44 defected kernel: [ 1188.447446] ehci_hcd 0000:00:1d.7: PCI INT A -> GSI 20 (level, low) -> IRQ 20 > Sep 9 21:52:44 defected kernel: [ 1188.447461] ehci_hcd 0000:00:1d.7: setting latency timer to 64 > Sep 9 21:52:44 defected kernel: [ 1188.447519] ehci_hcd 0000:00:1d.7: PCI INT A disabled > Sep 9 21:52:44 defected kernel: [ 1188.447588] ehci_hcd 0000:00:1d.7: PME# enabled
Reproduced this again, and the above loop happens when reconnecting the network cable.
So when network is working fine and I disconnetc the cable, this appears in the logs:
Sep 9 23:35:55 defected kernel: [ 5931.492189] e1000e: eth0 NIC Link is Down Sep 9 23:35:55 defected kernel: [ 5931.662818] e1000e 0000:00:19.0: PCI INT A disabled Sep 9 23:35:55 defected kernel: [ 5931.662836] e1000e 0000:00:19.0: PME# enabled Sep 9 23:35:55 defected kernel: [ 5931.676060] ehci_hcd 0000:00:1d.7: BAR 0: set to [mem 0xfed1c000-0xfed1c3ff] (PCI address [0xfed1c000-0xfed1c3ff]) Sep 9 23:35:55 defected kernel: [ 5931.676093] ehci_hcd 0000:00:1d.7: restoring config space at offset 0xf (was 0x100, writing 0x104) Sep 9 23:35:55 defected kernel: [ 5931.676132] ehci_hcd 0000:00:1d.7: restoring config space at offset 0x1 (was 0x2900000, writing 0x2900102) Sep 9 23:35:55 defected kernel: [ 5931.683253] ehci_hcd 0000:00:1d.7: PME# disabled Sep 9 23:35:55 defected kernel: [ 5931.683276] ehci_hcd 0000:00:1d.7: PCI INT A -> GSI 20 (level, low) -> IRQ 20 Sep 9 23:35:55 defected kernel: [ 5931.683290] ehci_hcd 0000:00:1d.7: setting latency timer to 64 Sep 9 23:35:55 defected kernel: [ 5931.683350] ehci_hcd 0000:00:1d.7: PCI INT A disabled Sep 9 23:35:55 defected kernel: [ 5931.683412] ehci_hcd 0000:00:1d.7: PME# enabled Sep 9 23:35:55 defected kernel: [ 5931.704067] ehci_hcd 0000:00:1a.7: BAR 0: set to [mem 0xfed1c400-0xfed1c7ff] (PCI address [0xfed1c400-0xfed1c7ff]) Sep 9 23:35:55 defected kernel: [ 5931.704099] ehci_hcd 0000:00:1a.7: restoring config space at offset 0xf (was 0x300, writing 0x30a) Sep 9 23:35:55 defected kernel: [ 5931.704137] ehci_hcd 0000:00:1a.7: restoring config space at offset 0x1 (was 0x2900000, writing 0x2900102) Sep 9 23:35:55 defected kernel: [ 5931.711840] ehci_hcd 0000:00:1a.7: PME# disabled Sep 9 23:35:55 defected kernel: [ 5931.711863] ehci_hcd 0000:00:1a.7: PCI INT C -> GSI 22 (level, low) -> IRQ 22 Sep 9 23:35:55 defected kernel: [ 5931.711877] ehci_hcd 0000:00:1a.7: setting latency timer to 64 Sep 9 23:35:55 defected kernel: [ 5931.711948] ehci_hcd 0000:00:1a.7: PCI INT C disabled Sep 9 23:35:55 defected kernel: [ 5931.712045] ehci_hcd 0000:00:1a.7: PME# enabled
When I reconnect the cable again one minute later, there is no information anymore about e1000e in the kernel logs and ehci_hcd ends up in the endless loop.
-- Frederik Himpe <fhimpe@telenet.be>
| |