[lkml]   [2011]   [Sep]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Patch in this message
    Subject[PATCH 2/3] [media] tvp5150: Add video format registers configuration values
    The tvp5150 video decoder has two operation modes to configure the video
    standard used.

    If auto-switch mode is enable, the device can sense the signal and detect which
    video standard the device is operating. Also the device can be forced to use a
    user defined video standard.

    Each operation mode uses a different register and the bitmask values to
    represent each standard is different.

    So we add video standard constants for both autoswitch and no-autoswitch mode.

    Signed-off-by: Javier Martinez Canillas <>
    drivers/media/video/tvp5150_reg.h | 17 ++++++++++++++++-
    1 files changed, 16 insertions(+), 1 deletions(-)

    diff --git a/drivers/media/video/tvp5150_reg.h b/drivers/media/video/tvp5150_reg.h
    index 4240043..25a9949 100644
    --- a/drivers/media/video/tvp5150_reg.h
    +++ b/drivers/media/video/tvp5150_reg.h
    @@ -45,7 +45,22 @@

    /* Reserved 1Fh-27h */

    -#define TVP5150_VIDEO_STD 0x28 /* Video standard */
    +#define VIDEO_STD_MASK (0x07 >> 1)
    +#define TVP5150_VIDEO_STD 0x28 /* Video standard */
    +#define VIDEO_STD_AUTO_SWITCH_BIT 0x00
    +#define VIDEO_STD_NTSC_MJ_BIT 0x02
    +#define VIDEO_STD_PAL_BDGHIN_BIT 0x04
    +#define VIDEO_STD_PAL_M_BIT 0x06
    +#define VIDEO_STD_NTSC_4_43_BIT 0x0a
    +#define VIDEO_STD_SECAM_BIT 0x0c
    +#define VIDEO_STD_NTSC_MJ_BIT_AS 0x01
    +#define VIDEO_STD_PAL_BDGHIN_BIT_AS 0x03
    +#define VIDEO_STD_PAL_M_BIT_AS 0x05
    +#define VIDEO_STD_NTSC_4_43_BIT_AS 0x09
    +#define VIDEO_STD_SECAM_BIT_AS 0x0b

    /* Reserved 29h-2bh */


     \ /
      Last update: 2011-10-01 02:37    [W:0.020 / U:9.312 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site