lkml.org 
[lkml]   [2011]   [Jul]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 3/4] regmap: Add SPI bus support
On Thu, Jul 14, 2011 at 08:53:27PM -0600, Grant Likely wrote:
> On Sat, Jul 09, 2011 at 01:50:43PM +0900, Mark Brown wrote:

> > obj-$(CONFIG_I2C) += regmap-i2c.o
> > +obj-$(CONFIG_SPI) += regmap-spi.o

> I would think this code should live with drivers/spi.c And similar
> for the i2c implementation.

There was a bit about this in the cover mail - it's the interace
stability issue again, the plan is to move them once we're more
confident that the interface used will stay stable.

> > +{
> > + struct spi_device *spi = to_spi_device(dev);
> > + struct spi_message m;
> > + struct spi_transfer t[2];

> > + spi_message_init(&m);
> > +
> > + memset(&t, 0, sizeof(t));

> If you do:

> struct spi_transfer t[2] = { {.tx_buf = reg, .len = reg_len},
> {.tx_buf = val, .len = val_len}};

> Then the memset() and t[0]/t[1] lines can all be culled.

That does the init to zero?

> > + t[1].tx_buf = val;
> > + t[1].len = val_len;
> > + spi_message_add_tail(&t[0], &m);

> t[0]?

Yes, that's been fixed in git for a little while now.


\
 
 \ /
  Last update: 2011-07-15 06:41    [W:0.105 / U:0.928 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site