lkml.org 
[lkml]   [2011]   [Jul]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/6 v2] PM / Domains: Set device state to "active" during system resume
Date
From: Rafael J. Wysocki <rjw@sisk.pl>

The runtime PM status of devices in a power domain that is not
powered off in pm_genpd_complete() should be set to "active", because
those devices are operational at this point. Some of them may not be
in use, though, so make pm_genpd_complete() call pm_runtime_idle()
in addition to pm_runtime_set_active() for each of them.

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
---
drivers/base/power/domain.c | 2 ++
1 file changed, 2 insertions(+)

Index: linux-2.6/drivers/base/power/domain.c
===================================================================
--- linux-2.6.orig/drivers/base/power/domain.c
+++ linux-2.6/drivers/base/power/domain.c
@@ -786,7 +786,9 @@ static void pm_genpd_complete(struct dev

if (run_complete) {
pm_generic_complete(dev);
+ pm_runtime_set_active(dev);
pm_runtime_enable(dev);
+ pm_runtime_idle(dev);
}
}



\
 
 \ /
  Last update: 2011-07-10 11:13    [W:0.084 / U:0.420 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site