lkml.org 
[lkml]   [2011]   [Jul]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFC PATCH -tip ] [BUGFIX] x86: Remove preempt disabling from kprobes
Date
Steven Rostedt reported that putting kprobe on the instruction which
loads preempt_count causes the wrong result, as below.

Kprobes requires preemption to be disabled as it single steps the code
it replaced with a breakpoint. But because the code that is single
stepped could be reading the preempt count, the kprobe disabling of the
preempt count can cause the wrong value to end up as a result. Here's an
example:

If we add a kprobe on a inc_preempt_count() call:

[ preempt_count = 0 ]

ld preempt_count, %eax <<--- trap

<trap>
preempt_disable();
[ preempt_count = 1]
setup_singlestep();
<trap return>

[ preempt_count = 1 ]

ld preempt_count, %eax

[ %eax = 1 ]

<trap>
post_kprobe_handler()
preempt_enable_no_resched();
[ preempt_count = 0 ]
<trap return>

[ %eax = 1 ]

add %eax,1

[ %eax = 2 ]

st %eax, preempt_count

[ preempt_count = 2 ]


We just caused preempt count to increment twice when it should have only
incremented once, and this screws everything else up.

To solve this, I've removed preempt disabling code from kprobes,
since the breakpoint exception and kprobes single step routine
disables interrupts, it doesn't need to disable preemption while
single-stepping anymore.

This patch is for -tip tree, and it can be applied to linus tree too.

Signed-off-by: Masami Hiramatsu <masami.hiramatsu.pt@hitachi.com>
Reported-by: Steven Rostedt <rostedt@goodmis.org>
---

arch/x86/kernel/kprobes.c | 18 ++++++------------
1 files changed, 6 insertions(+), 12 deletions(-)

diff --git a/arch/x86/kernel/kprobes.c b/arch/x86/kernel/kprobes.c
index f1a6244..5de9cfb 100644
--- a/arch/x86/kernel/kprobes.c
+++ b/arch/x86/kernel/kprobes.c
@@ -475,7 +475,6 @@ static void __kprobes setup_singlestep(struct kprobe *p, struct pt_regs *regs,
* stepping.
*/
regs->ip = (unsigned long)p->ainsn.insn;
- preempt_enable_no_resched();
return;
}
#endif
@@ -542,12 +541,13 @@ static int __kprobes kprobe_handler(struct pt_regs *regs)

addr = (kprobe_opcode_t *)(regs->ip - sizeof(kprobe_opcode_t));
/*
- * We don't want to be preempted for the entire
- * duration of kprobe processing. We conditionally
- * re-enable preemption at the end of this function,
- * and also in reenter_kprobe() and setup_singlestep().
+ * We don't want to be preempted for the entire duration of kprobe
+ * processing. This should be done by disabling interrupts instead
+ * of incrementing preempt_count, because if the probed instruction
+ * reads the count, it will get a wrong value.
+ * Disabling irq is done by breakpoint exception.
*/
- preempt_disable();
+ BUG_ON(!irqs_disabled());

kcb = get_kprobe_ctlblk();
p = get_kprobe(addr);
@@ -583,7 +583,6 @@ static int __kprobes kprobe_handler(struct pt_regs *regs)
* the original instruction.
*/
regs->ip = (unsigned long)addr;
- preempt_enable_no_resched();
return 1;
} else if (kprobe_running()) {
p = __this_cpu_read(current_kprobe);
@@ -593,7 +592,6 @@ static int __kprobes kprobe_handler(struct pt_regs *regs)
}
} /* else: not a kprobe fault; let the kernel handle it */

- preempt_enable_no_resched();
return 0;
}

@@ -917,7 +915,6 @@ static int __kprobes post_kprobe_handler(struct pt_regs *regs)
}
reset_current_kprobe();
out:
- preempt_enable_no_resched();

/*
* if somebody else is singlestepping across a probe point, flags
@@ -951,7 +948,6 @@ int __kprobes kprobe_fault_handler(struct pt_regs *regs, int trapnr)
restore_previous_kprobe(kcb);
else
reset_current_kprobe();
- preempt_enable_no_resched();
break;
case KPROBE_HIT_ACTIVE:
case KPROBE_HIT_SSDONE:
@@ -1098,7 +1094,6 @@ int __kprobes longjmp_break_handler(struct kprobe *p, struct pt_regs *regs)
memcpy((kprobe_opcode_t *)(kcb->jprobe_saved_sp),
kcb->jprobes_stack,
MIN_STACK_SIZE(kcb->jprobe_saved_sp));
- preempt_enable_no_resched();
return 1;
}
return 0;
@@ -1530,7 +1525,6 @@ static int __kprobes setup_detour_execution(struct kprobe *p,
regs->ip = (unsigned long)op->optinsn.insn + TMPL_END_IDX;
if (!reenter)
reset_current_kprobe();
- preempt_enable_no_resched();
return 1;
}
return 0;


\
 
 \ /
  Last update: 2011-07-01 15:21    [W:0.313 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site