lkml.org 
[lkml]   [2011]   [Jun]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRE: [PATCH] [SCSI] LIBSAS: fix libsas link error issue

>> I get the issue like this:
>> 1. HBA support 3Gbps, level 1 expander support 6Gbps, and level 2 expander
>> support 6Gbps;
>> 2. level 1 is fine, and find that level 2 link rate is 6Gbps in DISCOVER
command
>> response.
>> 3. LIBSAS think level 2 is 6Gbps by sas_ex_get_linkrate function, and send
>> command to level 2 expander
>> 4. LIBSAS link error.
>>
>[Jack Wang]
>What do you mean by "LIBSAS link error", OPEN_REJECT(CONNECTION RATE NOT
>SUPPORTED)? LIBSAS only get the error event through LLDD.
>According to SAS2r15 7.8.3
I mean that HBA get link error. Sorry.

>A SAS initiator port shall set the initial CONNECTION RATE field to:
>a) the highest supported connection rate supported by a potential pathway as
determined during the
>discover process (e.g., based on the logical link rates of each logical link
reported in the SMP
>DISCOVER responses); or
Sas_ex_get_linkrate function

>b) the logical link rate of the logical phy used to transmit the OPEN
address frame.
MVSAS get value of linkrate from sas_ex_get_linkrate function(child->linkrate)

>If a SAS initiator port selected a connection rate based on discover process
information but the connection
>request results in OPEN_REJECT (CONNECTION RATE NOT SUPPORTED), then the
discover process
>information is no longer current and the discover process should be run
again.

Fail again.



\
 
 \ /
  Last update: 2011-06-16 04:01    [W:0.044 / U:1.752 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site