[lkml]   [2011]   [May]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 1/2] mfd: Add ASIC3 LED support
Hi Paul,

On Mon, May 02, 2011 at 11:16:23PM +0100, Paul Parsons wrote:
> Hi Samuel,
> --- On Mon, 2/5/11, Samuel Ortiz <> wrote:
> > Where is the LED driver ?
> It was posted separately - [PATCH 2/2] leds: Add ASIC3 LED support - since drivers/mfd and drivers/leds are maintained separately. Sorry, I should have cross copied them.
I believe the LED driver is dependent on the asic3.h changes this patches
carry. So both patches should go in at the same time, probably through my

> > > -static int asic3_clk_enable(struct asic3 *asic,
> > struct asic3_clk *clk)
> > > +static void asic3_clk_enable(struct asic3 *asic,
> > struct asic3_clk *clk)
> > Although a valid change, this is unrelated to this patch.
> Not completely unrelated; I call asic3_clk_enable() and found it simpler to remove the unnecessary return value rather than check it.
I understood that. And I am fine with the change, but I would like it to be a
separate patch.

> > > +    asic->gpio.label = "asic3";
> > Ditto.
> Agreed; that was left in by mistake.
> Should I resubmit?
Yes, please. Also, I'm deprecating the mfd_data usage in my mfd-2.6 tree, so
you should fix your code according to that.

Thanks in advance.


Intel Open Source Technology Centre
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at
Please read the FAQ at

 \ /
  Last update: 2011-05-03 10:35    [W:0.039 / U:1.796 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site