Messages in this thread | | | Date | Wed, 20 Apr 2011 14:04:47 +0200 | Subject | Re: [PATCH 1/2] gpio: add pin biasing and drive mode to gpiolib | From | Linus Walleij <> |
| |
2011/4/18 Ben Nizette <bn@niasdigital.com>: > > On 18/04/2011, at 7:37 AM, Linus Walleij wrote: > >> From: Linus Walleij <linus.walleij@linaro.org> >> >> This adds two functions for struct gpio_chip chips to provide pin >> bias and drive mode settings for individual pins. Implementers does >> this a bit differently and usually there are a few possible modes you >> can select, I'm providing a few common modes for biasing and driving >> pins. >> >> Since we have no previous hacked-up arch-specific drivers for this >> we can avoid any __override_functions and we just allow this to be >> properly implemented using gpiolib. Further the function is made >> non-mandatory, if it is not defined for the chip it will be silently >> ignored. > > I don't like this much. Why does the driver ever need to do this? When > should a driver even try this this given you can't guarantee any results > and as such it's only ever a hint?
I don't get it. Who says the interface should be used by drivers? It could just as well (and much more likely) be the board code.
> As far as I can see it would be > much much better if you just replaced
> > platform_device_register(...) > > with > > set_up_pins(...) > platform_device_register(...) > > in board code (or add a device tree, erm, leaf or whatever).
Yes that is one of the use cases for this patch set. We seem to be in 100% agreement :-)
> So in short - what's the use case? Which driver requires this?
You just gave the use case yourself.
The intent of the patch set it to generalize the GPIO drivers so they can be pushed down into drivers/gpio/* where they belong.
Since only the individual GPIO driver knows for example where to find the memory-mapped I/O region it has to reside with the GPIO driver(s).
Even if these pin-specific calls are only called from board code the mechanism is still needed in order to move, consolidate and abstract the GPIO code into the gpio subsystem.
Yours, Linus Walleij -- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |