lkml.org 
[lkml]   [2011]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH, v2] x86/PCI: don't export a __devinit function
Exporting a __devinit function (pcibios_scan_specific_bus()) isn't
correct. (Michal, any reason why modpost only warns about exported
__init functions?) Short of being able to think of a better solution,
and short of making the whole call tree (reaching into the arch-
independent part of the PCI subsystem) non-__devinit, export the
symbol only when HOTPLUG is enabled (which is always the case for non-
expert configurations), use section mismatch avoidance annotations for
that case (knowing that __devinit functions will not be discarded),
and mark the symbol __devinit only in the !HOTPLUG case.

Consequently, EDAC_I7CORE's use of that function then has to depend on
CONFIG_HOTPLUG. A fundamental question of course if whether this driver
has to use that function in the first place (i.e. whether it wouldn't
be better to just remove the export) - the problem it tries to address
happens on other systems too, but the PCI bus the devices in question
live on isn't necessarily bus 255. For the affected system I have, the
alternative approach is to set pcibios_last_bus from __pci_mmcfg_init()
based on the highest bus number on segment 0 being covered by MCFG.

v2: Rather than making the whole i7core_edac driver depend on HOTPLUG,
make only the code using the symbol in question depend on this
option (unless built into the kernel).

Signed-off-by: Jan Beulich <jbeulich@novell.com>
Cc: Mauro Carvalho Chehab <mchehab@redhat.com>
Cc: Aristeu Sergio <arozansk@redhat.com>
Cc: Michal Marek <mmarek@suse.cz>

---
arch/x86/pci/legacy.c | 21 ++++++++++++++++++---
drivers/edac/i7core_edac.c | 6 ++++++
2 files changed, 24 insertions(+), 3 deletions(-)

--- 2.6.38-rc6/arch/x86/pci/legacy.c
+++ 2.6.38-rc6-x86-pci-section-conflict/arch/x86/pci/legacy.c
@@ -36,7 +36,23 @@ int __init pci_legacy_init(void)
return 0;
}

-void __devinit pcibios_scan_specific_bus(int busn)
+#ifdef CONFIG_HOTPLUG
+static void __ref
+#else
+static inline void
+#endif
+_pci_scan_bus_on_node(int busno, int node)
+{
+ pci_scan_bus_on_node(busno, &pci_root_ops, node);
+}
+
+#ifdef CONFIG_HOTPLUG
+EXPORT_SYMBOL_GPL(pcibios_scan_specific_bus);
+void
+#else
+void __devinit
+#endif
+pcibios_scan_specific_bus(int busn)
{
int devfn;
long node;
@@ -51,12 +67,11 @@ void __devinit pcibios_scan_specific_bus
l != 0x0000 && l != 0xffff) {
DBG("Found device at %02x:%02x [%04x]\n", busn, devfn, l);
printk(KERN_INFO "PCI: Discovered peer bus %02x\n", busn);
- pci_scan_bus_on_node(busn, &pci_root_ops, node);
+ _pci_scan_bus_on_node(busn, node);
return;
}
}
}
-EXPORT_SYMBOL_GPL(pcibios_scan_specific_bus);

int __init pci_subsys_init(void)
{
--- 2.6.38-rc6/drivers/edac/i7core_edac.c
+++ 2.6.38-rc6-x86-pci-section-conflict/drivers/edac/i7core_edac.c
@@ -1267,6 +1267,11 @@ static void i7core_put_all_devices(void)

static void __init i7core_xeon_pci_fixup(const struct pci_id_table *table)
{
+/*
+ * pcibios_scan_specific_bus() is __devinit and thus only exported when
+ * CONFIG_HOTPLUG is defined.
+ */
+#if !defined(MODULE) || defined(CONFIG_HOTPLUG)
struct pci_dev *pdev = NULL;
int i;

@@ -1284,6 +1289,7 @@ static void __init i7core_xeon_pci_fixup
pci_dev_put(pdev);
table++;
}
+#endif
}

static unsigned i7core_pci_lastbus(void)




\
 
 \ /
  Last update: 2011-02-22 09:37    [W:0.580 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site