lkml.org 
[lkml]   [2011]   [Feb]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    Date
    From
    Subject[268/272] xhci: Resume bus on any port status change.
    2.6.37-stable review patch.  If anyone has any objections, please let us know.

    ------------------

    From: Sarah Sharp <sarah.a.sharp@linux.intel.com>

    commit 7111ebc97ed53a32314011c85a6f235f0dab8ae8 upstream.

    The original code that resumed the USB bus on a port status change would
    only do so when there was a device connected to the port. If a device was
    just disconnected, the event would be queued for khubd, but khubd wouldn't
    run. That would leave the connect status change (CSC) bit set.

    If a USB device was plugged into that same port, the xHCI host controller
    would set the current connect status (CCS) bit. But since the CSC bit was
    already set, it would not generate an interrupt for a port status change
    event. That would mean the user could "Safely Remove" a device, have the
    bus suspend, disconnect the device, re-plug it in, and then the device
    would never be enumerated.

    Plugging in a different device on another port would cause the bus to
    resume, and khubd would notice the re-connected device. Running lsusb
    would also resume the bus, leading users to report the problem "went away"
    when using diagnostic tools.

    The solution is to resume the bus when a port status change event is
    received, regardless of the port status.

    Thank you very much to Maddog for helping me track down this Heisenbug.

    This patch should be queued for the 2.6.37 stable tree.

    Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
    Reported-by: Jon 'maddog' Hall <maddog@li.org>
    Tested-by: Andiry Xu <andiry.xu@amd.com>
    Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

    ---
    drivers/usb/host/xhci-ring.c | 2 +-
    1 file changed, 1 insertion(+), 1 deletion(-)

    --- a/drivers/usb/host/xhci-ring.c
    +++ b/drivers/usb/host/xhci-ring.c
    @@ -1188,7 +1188,7 @@ static void handle_port_status(struct xh

    addr = &xhci->op_regs->port_status_base + NUM_PORT_REGS * (port_id - 1);
    temp = xhci_readl(xhci, addr);
    - if ((temp & PORT_CONNECT) && (hcd->state == HC_STATE_SUSPENDED)) {
    + if (hcd->state == HC_STATE_SUSPENDED) {
    xhci_dbg(xhci, "resume root hub\n");
    usb_hcd_resume_root_hub(hcd);
    }



    \
     
     \ /
      Last update: 2011-02-16 01:55    [W:3.290 / U:1.344 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site