lkml.org 
[lkml]   [2011]   [Dec]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] serial: bfin-uart: Remove ASYNC_CTS_FLOW flag for hardware automatic CTS.
Date
From: Sonic Zhang <sonic.zhang@analog.com>

Blackfin uart supports automatic CTS trigger when hardware flow control is enabled.
No need to start and top tx in CTS interrupt. So, remote ASYNC_CTS_FLOW flag.

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
---
drivers/tty/serial/bfin_uart.c | 17 ++++++++++++++---
1 files changed, 14 insertions(+), 3 deletions(-)

diff --git a/drivers/tty/serial/bfin_uart.c b/drivers/tty/serial/bfin_uart.c
index 57747c4..929dd11 100644
--- a/drivers/tty/serial/bfin_uart.c
+++ b/drivers/tty/serial/bfin_uart.c
@@ -116,11 +116,20 @@ static void bfin_serial_set_mctrl(struct uart_port *port, unsigned int mctrl)
static irqreturn_t bfin_serial_mctrl_cts_int(int irq, void *dev_id)
{
struct bfin_serial_port *uart = dev_id;
- unsigned int status;
-
- status = bfin_serial_get_mctrl(&uart->port);
+ unsigned int status = bfin_serial_get_mctrl(&uart->port);
#ifdef CONFIG_SERIAL_BFIN_HARD_CTSRTS
+ struct tty_struct *tty = uart->port.state->port.tty;
+
UART_CLEAR_SCTS(uart);
+ if (tty->hw_stopped) {
+ if (status) {
+ tty->hw_stopped = 0;
+ uart_write_wakeup(&uart->port);
+ }
+ } else {
+ if (!status)
+ tty->hw_stopped = 1;
+ }
#endif
uart_handle_cts_change(&uart->port, status & TIOCM_CTS);

@@ -1358,7 +1367,9 @@ static int bfin_serial_probe(struct platform_device *pdev)
uart->cts_pin = -1;
else {
uart->cts_pin = res->start;
+#ifdef CONFIG_SERIAL_BFIN_CTSRTS
uart->port.flags |= ASYNC_CTS_FLOW;
+#endif
}

res = platform_get_resource(pdev, IORESOURCE_IO, 1);
--
1.7.0.4



\
 
 \ /
  Last update: 2011-12-09 07:09    [W:0.059 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site