Messages in this thread | | | Date | Wed, 07 Dec 2011 15:59:47 +0200 | From | Jarkko Nikula <> | Subject | Re: [regression] Re: [PATCH 3/7] mfd: twl4030-irq: drop the kthread |
| |
On 12/07/2011 03:39 PM, Felipe Balbi wrote: >> I'll try to flash a system to NAND, since I can't seem to just get the >> MMC to work when the cover is open and the device is connected to the >> jig to see if I can see something from serial console. >> >> You don't have any idea about what to try? > > you could cut the back cover so that it just fits the device on the jig > (I did that to an old cover), then it works just fine :-) > You could also go without breaking the back cover by putting a magnet on top the hal sensor (like tape a piece from a fridge magnet). See here the place:
http://talk.maemo.org/showthread.php?p=1008775
Another option is to to set .gpio_cd = -EINVAL for external mmc in arch/arm/mach-omap2/board-rx51-peripherals.c.
-- Jarkko
| |