[lkml]   [2011]   [Dec]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: [rt2x00-users] Poor performance and lockup with rt2800usb and Asus USB-N13 adapter
    On Tue, Dec 20, 2011 at 03:43:17PM +0100, Stanislaw Gruszka wrote:
    > I just discovered that at least some problems are related with power
    > save. After "iwconfig wlanX power off" I have pretty short ping times
    > and good throughput, both comparable with vendor driver. But I did not
    > check that on all adapters that I have yet.
    > Looking a bit more at that seem we stop and wake queues several times
    > between sending each frame. Looks like that thing need to be optimized
    > in mac80211, or some parameters have to be setup properly by rt2x00 ...
    > Also rt2800 PCI and SOC have PS disabled by default ...

    There is no bug with ping latencies when power save is enabled. Ping
    send packet every second, between that we put driver in power save
    mode (i.e. tell AP that we are sleeping and it has to buffer frame
    to us). When we send ping packet, we wake up and receive packet from
    a AP after longer time than in normal operation mode.

    I did more testing here and I have one device that works very bad,
    no matter if PS is configured or not. It is

    phy6 -> rt2x00_set_chip: Info - Chipset detected - rt: 3071, rf: 0008, rev: 021c.

    I'm going to investigate problems with that device, hopefully these are the
    same problems that Robert and Andreas have.


     \ /
      Last update: 2011-12-22 17:21    [W:0.023 / U:38.976 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site