Le dimanche 02 octobre 2011 à 01:33 -0400, starlight@binnacle.cx a
écrit :
> Did some additional testing and have an update:
> 
> 1) compiled 2.6.32.27 with CGROUP and NAMESPACES
> disabled as much as 'make menuconfig' will allow.
> Made no difference on performance--same exact
> result.
> 
> 2) did observe that the IRQ rate is 100k on
> 2.6.32.27 where it is 33k on 2.6.18(rhel).
> 
> 3) compiled 2.6.39.4 with same config used
> in (1) above, allowing 'make menuconfig'
> to fill in differences.  Tried 'make defconfig'
> but it left out too many modules and the kernel
> would not even install.  The config used to
> build this kernel is attached.
> 
> .39 Runs 7% better than .32 but still 27.5% worse
> than 2.6.18(rhel) on total reported CPU and 97%
> worse on system CPU.  The IRQ rate was 50k here.
> 
> 4) Ran the full 30 minute test again with 
> 
>    perf record -a
> 
> running and generated a report (attached).
> This was done in packet socket mode because
> all the newer kernels have some serious bug
> where UDP data is not delivered to about
> half of the sockets even though it arrives
> to the interface.  [I've been ignoring
> this since packet socket performance is
> close to UDP socket performance and I'm more
> worried about network overhead than the
> UDP bug.  Comparisons are with same mode
> test on the 2.6.18(rhel) kernel.]
> 
> The application '_raw_spin_lock' number
> stands out to me--makes me think that
> 2.6.39 has greater bias toward spinning
> futexes than 2.6.18(rhel) as the user
> CPU was 6.5% higher.  The .32(rhel) kernel
> is exactly the same on user CPU.  In UDP
> mode there is little or none of this lock-
> contention CPU--it appears here due to the
> need for queuing messages to worker
> threads in packet-socket mode.
> 
> Beyond that it looks to me like the kernel paths
> have no notable hot-spots, which makes me think
> that the code path has gotten longer everywhere
> or that subtle changes have interacted badly
> with cache behavior to cause the performance
> loss.  However someone who knows the kernel
> code may see things here that I cannot.
> 
> -----
> 
> This popped into my head.  About two years ago
> I tried benchmarking SLES RT with our application.
> The results were horrifically bad.  Don't know
> if anything from the RT work was merged into
> the kernel, but my overall impression was that
> RT traded CPU for latency to the extreme point
> where any application that used more than
> 10% of the much higher CPU consumption would
> not work.  Haven't looked at latency during
> these tests, but I suppose if there are
> improvements it might be worth the extra CPU
> it's costing.  Any thoughts on this?

You might try to disable any fancy power saving mode in your machine.
Maybe on your machine, cost to enter/exit deep sleep state is too high.

I see nothing obvious in the profile but userland processing, futex
calls. 

Network processing seems to account less than 10% of total cpu...
All this sounds more a process scheduling regression than a network
stack one..

On new kernels, you can check if your udp sockets drops frames because
of rcvbuffer being full (cat /proc/net/udp, check last column 'drops')

To check if softirq processing hit some limits :
cat /proc/net/softnet_stat

Please send full "dmesg" output 



--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/