lkml.org 
[lkml]   [2011]   [Jan]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [KVM TSC trapping / migration 1/2] Add TSC trapping for SVM and VMX
From
Date

On 06.01.2011, at 12:30, Zachary Amsden wrote:

> On 01/06/2011 12:41 AM, Alexander Graf wrote:
>> Am 06.01.2011 um 11:10 schrieb Zachary Amsden<zamsden@redhat.com>:
>>
>>
>>> Reasons to trap the TSC are numerous, but we want to avoid it as much
>>> as possible for performance reasons.
>>>
>>> We provide two conservative modes via modules parameters and userspace
>>> hinting. First, the module can be loaded with "tsc_auto=1" as a module
>>> parameter, which turns on conservative TSC trapping only when it is
>>> required (when unstable TSC or faster KHZ CPU is detected).
>>>
>>> For userspace hinting, we enable trapping only if necessary. Userspace
>>> can hint that a VM needs a fixed frequency TSC, and also that SMP
>>> stability will be required. In that case, we conservatively turn on
>>> trapping when it is needed. In addition, users may now specify the
>>> desired TSC rate at which to run. If this rate differs significantly
>>> from the host rate, trapping will be enabled.
>>>
>>> There is also an override control to allow TSC trapping to be turned on
>>> or off unconditionally for testing.
>>>
>>> We indicate to pvclock users that the TSC is being trapped, to allow
>>> avoiding overhead and directly using RDTSCP (only for SVM). This
>>> optimization is not yet implemented.
>>>
>> When migrating, the implementation could switch from non-trapped to trapped, making it less attractive. The guest however does not get notified about this change. Same for the other way around.
>>
>
> That's a policy decision to be made by the userspace agent. It's better than the current situation, where there is no control at all of TSC rate. Here, we're flexible either way.
>
> Also note, moving to a faster processor, trapping kicks in... but the processor is faster, so no actual loss is noticed, and the problem corrects when the VM is power cycled.

Hrm. But even then the guest should be notified to enable it to act accordingly and just recalibrate instead of reboot, no? I'm not saying this is particularly interesting for kvmclock enabled guests, but think of all the < 2.6.2x Linux, *BSD, Solaris, Windows etc. VMs out there that might have an easy means of triggering recalibration (or at least could introduce it), but writing a new clock source is a lot of work.

Of course, sending the notification through a userspace agent would also work. That one would have to be notified about the change too though.

>> Would it make sense to add a kvmclock interrupt to notify the guest of such a change?
>
> kvmclock is immune to frequency changes, so it needs no interrupt, it just has a version controlled shared area, which is reset.


>>> We indicate to pvclock users that the TSC is being trapped, to allow
>>> avoiding overhead and directly using RDTSCP (only for SVM). This
>>> optimization is not yet implemented.
>>

That doesn't sound to me like they're unaffected?


Alex

>>


\
 
 \ /
  Last update: 2011-01-06 12:41    [W:2.246 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site