[lkml]   [2011]   [Jan]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: [BUG/REGRESSION] DRM / i915 / 2.6.37 and 2.6.38-rc*: DVI output gets disabled/reenabled under load
    On Mon, 24 Jan 2011 19:48:55 +0100, Knut Petersen <> wrote:
    > On an AOpen i915GMm-HFS I see the following problem:
    > The LCD panel connected to DVI-1 gets disabled and then reenabled
    > under high system load (e.g. -j 15 kernel compile) if I am working on the
    > framebuffer console (no problems in X).

    DVI detection is essentially retrieving the EDID by bitbanging on the DDC.
    This is timing sensitive and I suspect that is being interrupted by the
    system activity causing the EDID data to be returned corrupted. Is that
    supported by any warnings in dmesg? Does increasing the drm.debug level to
    0x6 reveal any more significant information?

    Not sure how using the unaccelerated fbcon ties in just yet. It's an extra
    source of latency vs X, but I would expect to impact upon DVI detection.

    You can simply disable the polling with
    'echo n > /sys/module/drm_kms_helper/parameter/poll'

    Chris Wilson, Intel Open Source Technology Centre

     \ /
      Last update: 2011-01-24 20:15    [W:0.018 / U:42.268 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site