lkml.org 
[lkml]   [2010]   [Aug]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: A question of perf NMI handler
On Wed, Aug 04, 2010 at 12:01:16PM +0200, Robert Richter wrote:
> There is no general mechanism for recording the NMI source (except if
> it was external triggered, e.g. by the southbridge). Also, all nmis
> are mapped to NMI vector 2 and therefore there is no way to find out
> the reason by using apic mask registers.

This is no different than a shared interrupt, no? All the nmi handlers
need to check their own sources to see if they triggered it. You can't
expect the generic nmi handler to determine this.

>
> Now, if multiple perfctrs trigger an nmi, it may happen that a handler
> has nothing to do because the counter was already handled by the
> previous one. Thus, it is valid to have unhandled nmis caused by
> perfctrs.
>
> So, with counters enabled we always have to return stop for *all* nmis
> as we cannot detect that it was an perfctr nmi. Otherwise we could
> trigger an unhandled nmi. To ensure that all other nmi handlers are
> called, the perfctr's nmi handler must have the lowest priority. Then,
> the handler will be the last in the chain.

But the cases this break are, external NMI buttons, broken firmware that
causes SERRs on the PCI bus, and any other general hardware failures.

So what the perf handler does is really unacceptable. The only reason we
are noticing this now is because I put the nmi_watchdog on top of the perf
subsystem, so it always has a user and will trigger NOTIFY_STOP. Before,
it never had a registerd user so instead returned NOTIFY_DONE and
everything worked great.

Cheers,
Don


\
 
 \ /
  Last update: 2010-08-04 16:03    [W:0.090 / U:0.764 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site