lkml.org 
[lkml]   [2010]   [Aug]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] serial: Add CONSOLE_POLL support for uartlite
On 08/09/2010 05:07 AM, Michal Simek wrote:
> CONSOLE_POLL support for uartlite enables
> KGDB debugging over serial line.
>
> Signed-off-by: Michal Simek <monstr@monstr.eu>
> ---
> drivers/serial/uartlite.c | 26 +++++++++++++++++++++++++-
> 1 files changed, 25 insertions(+), 1 deletions(-)
>
> diff --git a/drivers/serial/uartlite.c b/drivers/serial/uartlite.c
> index caf085d..ce1f3e0 100644
> --- a/drivers/serial/uartlite.c
> +++ b/drivers/serial/uartlite.c
> @@ -322,6 +322,26 @@ static int ulite_verify_port(struct uart_port *port, struct serial_struct *ser)
> return -EINVAL;
> }
>
> +#ifdef CONFIG_CONSOLE_POLL
> +static int ulite_get_poll_char(struct uart_port *port)
> +{
> + while (!(ioread32be(port->membase + ULITE_STATUS)
> + & ULITE_STATUS_RXVALID))
> + cpu_relax();
> +
> + return ioread32be(port->membase + ULITE_RX);
> +}



After kdb was merged, the CONSOLE_POLL API had a subtle change where
all I/O drivers should return immediately with a return of
NO_POLL_CHAR in order to allow more than one I/O driver to operate in
the same poll loop.


The patch should look like the following for the get_poll_char.

+static int ulite_get_poll_char(struct uart_port *port)
+{
+ if (!(ioread32be(port->membase + ULITE_STATUS)
+ & ULITE_STATUS_RXVALID))
+ return NO_POLL_CHAR;
+
+ return ioread32be(port->membase + ULITE_RX);
+}


If you agree to the change you can add my SOB.

Signed-off-by: Jason Wessel <jason.wessel@windriver.com>

Cheers,
Jason.



\
 
 \ /
  Last update: 2010-08-10 13:51    [W:0.918 / U:25.696 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site