On 07/31/2010 04:55 PM, Ondrej Zary wrote:
> I was testing two CyberPro 2000 based PCI cards on x86 and the machine always
> hanged completely when the cyber2000fb module was loaded. It seems that the
> card hangs when some registers are accessed too quickly after writing RAMDAC
> control register. With this patch, both card work.
>
> Add delay after RAMDAC control register write to prevent hangs on module load.
>
> Signed-off-by: Ondrej Zary<linux@rainbow-software.org>
>
> --- linux-2.6.35-rc2-orig/drivers/video/cyber2000fb.c	2010-06-06 05:43:24.000000000 +0200
> +++ linux-2.6.35-rc3/drivers/video/cyber2000fb.c	2010-07-27 23:12:37.000000000 +0200
> @@ -436,6 +436,8 @@ static void cyber2000fb_write_ramdac_ctr
>   	cyber2000fb_writeb(i | 4, 0x3cf, cfb);
>   	cyber2000fb_writeb(val, 0x3c6, cfb);
>   	cyber2000fb_writeb(i, 0x3cf, cfb);
> +	/* prevent card lock-up observed on x86 with CyberPro 2000 */
> +	cyber2000fb_readb(0x3cf, cfb);
>   }

IIRC, cyber2000 is basically an S3 graphics chip.  When working on s3fb, 
over a decade ago, ISTR needing a lot of MMIO register flushes -- dummy 
register reads -- to flush out just-written register writes.