[lkml]   [2010]   [Jun]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Subject[PATCH v3 0/4] hwmon: Driver for SMM665 Six-Channel Active DC Output Controller/Monitor
    This patchset adds support for the monitoring features of the Summit
    Microelectronics SMM665 Six-Channel Active DC Output Controller/Monitor.


    v2 changes:
    - Added (untested) support for SMM465, SMM764, and SMM766.
    - Added vref module parameter to support non-default values of VREF_ADC.
    - Added an explanation describing what the chip does with _min and _max limit
    - Removed alarm sysfs files (since the chip does not report alarm status in a
    register, alarm detection was implemented by comparing limits with ADC readings,
    which can as well be done in userland).
    - Replaced register enums with defines.
    - Made limit variable names better readable.
    - Removed retries from smm665_read_adc().
    - Check error reply from i2c_smbus_read_byte_data() and only accept ENXIO
    when expecting NACK.
    - Explained reason for byte swap after reading ADC registers in some more detail.
    - Added debug messages to display the error reason when reading ADC registers

    v3 changes:
    - Return error codes from smm665_read_adc().
    - Abort after first error in smm665_update_device() and return error code.
    - Return ADC read errors to user.
    - Added inX_lcrit and inX_crit attributes for min/max critical voltages.
    - Added tempX_lcrit attribute for critical low temperature.
    - Updated sysfs-interface to document support for new attributes.

     \ /
      Last update: 2010-06-25 00:09    [W:0.021 / U:54.288 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site