[lkml]   [2010]   [Jun]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: [PATCH 0/3] msm: Add gpiolib devices to MSM7x30 and QSD8x50.
    On Fri, 2010-06-18 at 12:12 -0700, Gregory Bean wrote:
    > Hi folks:
    > Here is a proposed patch series which adds the configuration and devices
    > needed to enable gpiolib on the MSM7x30 and QSD8x50 chipsets.
    > Patch 1 adds the register mapping information for all supported
    > MSM/QSD targets. I wasn't sure about adding register definitions for boards
    > which weren't yet using those definitions, but the alternative was to have
    > each following patch change gpio_hw.h over and over, so I put all the
    > definitions in at once. Thoughts?
    > Patch 2 adds the first target, the 7x30, as well as some generic macros
    > to ease the definition of the gpio devices and their platform data,
    > as this is long-winded, but mindless and repetitive work. I considered
    > putting the generic macro-definitions in their own patch, but without
    > any targets to use them it seemed a little silly to leave them on their
    > own and I ended up attaching them to the first patch to use them -
    > what do y'all think? Does it warrant being split up?
    > Patch 3 adds device configuration for the 8x50.

    Does it bisect?


    Sent by a consultant of the Qualcomm Innovation Center, Inc.
    The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.

     \ /
      Last update: 2010-06-18 21:29    [W:0.029 / U:31.480 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site