lkml.org 
[lkml]   [2010]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [2.6.35-rc1 regression] tg3 vpd r/w failed
From

Mikael I'm getting tired of continuing to add the proper
mailing list CC: for your sparc bug reports. Please make
sure to add sparclinux@vger.kernel.org to your reports
in the future.

Thanks.

> Booting 2.6.35-rc1 on a Sun Blade 2500 Red with builtin tg3 I get:
>
> tg3.c:v3.110 (April 9, 2010)
> PCI: Enabling device: (0000:00:03.0), cmd 2
> ...
> tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update.
> tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update.
> tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update.
> tg3 0000:00:03.0: eth0: Tigon3 [partno(none) rev 1002] (PCI:66MHz:64-bit) MAC address ...
> tg3 0000:00:03.0: eth0: attached PHY is 5703 (10/100/1000Base-T Ethernet) (WireSpeed[1])
> tg3 0000:00:03.0: eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1]
> tg3 0000:00:03.0: eth0: dma_rwctrl[763f0000] dma_mask[32-bit]
> ...
> tg3 0000:00:03.0: eth0: No firmware running
> tg3 0000:00:03.0: eth0: Link is up at 100 Mbps, full duplex
> tg3 0000:00:03.0: eth0: Flow control is on for TX and on for RX
>
> The three 'vpd r/w failed' messages are new and did not occur with 2.6.34
> or earlier kernels.
>
> /Mikael


\
 
 \ /
  Last update: 2010-06-02 00:35    [W:0.261 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site